Commit da91b89e authored by Vaibhav Hiremath's avatar Vaibhav Hiremath Committed by Paul Walmsley

ARM: OMAP2+: am335x: Change the wdt1 func clk src to per_32k clk

WDT1 module can take one of the below clocks as input functional
clock -
     - On-Chip 32K RC Osc [default/reset]
     - 32K from PRCM

The On-Chip 32K RC Osc clock is not an accurate clock-source as per
the design/spec, so as a result, for example, timer which supposed
to get expired @60Sec, but will expire somewhere ~@40Sec, which is
not expected by any use-case.

The solution here is to switch the input clock-source to PRCM
generated 32K clock-source during boot-time itself.
Signed-off-by: default avatarVaibhav Hiremath <hvaibhav@ti.com>
Cc: Santosh Shilimkar <santosh.shilimkar@ti.com>
Cc: Benoit Cousson <benoit.cousson@linaro.org>
Cc: Paul Walmsley <paul@pwsan.com>
parent 05cf03b6
...@@ -958,6 +958,14 @@ int __init am33xx_clk_init(void) ...@@ -958,6 +958,14 @@ int __init am33xx_clk_init(void)
clk_set_parent(&timer3_fck, &sys_clkin_ck); clk_set_parent(&timer3_fck, &sys_clkin_ck);
clk_set_parent(&timer6_fck, &sys_clkin_ck); clk_set_parent(&timer6_fck, &sys_clkin_ck);
/*
* The On-Chip 32K RC Osc clock is not an accurate clock-source as per
* the design/spec, so as a result, for example, timer which supposed
* to get expired @60Sec, but will expire somewhere ~@40Sec, which is
* not expected by any use-case, so change WDT1 clock source to PRCM
* 32KHz clock.
*/
clk_set_parent(&wdt1_fck, &clkdiv32k_ick);
return 0; return 0;
} }
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment