Commit dbdedbdf authored by Seth Forshee's avatar Seth Forshee Committed by John W. Linville

b43: only reload config after successful initialization

Commit 2a190322 (b43: reload phy and bss settings after core restarts)
introduced an unconditional call to b43_op_config() at the end of
b43_op_start(). When firmware fails to load this can wedge the system.
There's no need to reload the configuration after a failed
initialization anyway, so only make the call if initialization was
successful.

BugLink: http://bugs.launchpad.net/bugs/950295
Cc: Felix Fietkau <nbd@openwrt.org>
Cc: <stable@vger.kernel.org>
Signed-off-by: default avatarSeth Forshee <seth.forshee@canonical.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent 1ed2ec37
...@@ -4827,7 +4827,13 @@ static int b43_op_start(struct ieee80211_hw *hw) ...@@ -4827,7 +4827,13 @@ static int b43_op_start(struct ieee80211_hw *hw)
out_mutex_unlock: out_mutex_unlock:
mutex_unlock(&wl->mutex); mutex_unlock(&wl->mutex);
/* reload configuration */ /*
* Configuration may have been overwritten during initialization.
* Reload the configuration, but only if initialization was
* successful. Reloading the configuration after a failed init
* may hang the system.
*/
if (!err)
b43_op_config(hw, ~0); b43_op_config(hw, ~0);
return err; return err;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment