scsi: ufs: qcom: Check the return value of ufs_qcom_power_up_sequence()

If ufs_qcom_power_up_sequence() fails, then it makes no sense to enable the
lane clocks and continue ufshcd_hba_enable(). So let's check the return
value of ufs_qcom_power_up_sequence().
Reviewed-by: Andrew Halaney <ahalaney@redhat.com>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Link: https://lore.kernel.org/r/20231208065902.11006-9-manivannan.sadhasivam@linaro.org
Tested-by: Andrew Halaney <ahalaney@redhat.com> # sa8775p-ride
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/ufs/host/ufs-qcom.c

@@ -417,7 +417,10 @@ static int ufs_qcom_hce_enable_notify(struct ufs_hba *hba,
 
 	switch (status) {
 	case PRE_CHANGE:
-		ufs_qcom_power_up_sequence(hba);
+		err = ufs_qcom_power_up_sequence(hba);
+		if (err)
+			return err;
+
 		/*
 		 * The PHY PLL output is the source of tx/rx lane symbol
 		 * clocks, hence, enable the lane clocks only after PHY