ARM: defconfig: qcom: add APQ8060 DragonBoard devices

This default-enables the devices found on the APQ8060 DragonBoard
in the qcom_defconfig:

- EBI2 bus
- SMSC911x ethernet
- LEDs class and PM8058 LEDs driver, trigger and heartbeat
  trigger (so we get heartbeat on the board by default)
- IIO framework, including the HRTimer trigger, KXSD9
  accelerometer, MPU3050 gyroscope, AK8975 magnetometer and
  BMP085 pressure sensor
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>

arch/arm/configs/qcom_defconfig

@@ -58,6 +58,7 @@ CONFIG_CFG80211=y
 CONFIG_RFKILL=y
 CONFIG_DEVTMPFS=y
 CONFIG_DEVTMPFS_MOUNT=y
+CONFIG_QCOM_EBI2=y
 CONFIG_MTD=y
 CONFIG_MTD_BLOCK=y
 CONFIG_MTD_M25P80=y
@@ -78,6 +79,7 @@ CONFIG_NETDEVICES=y
 CONFIG_DUMMY=y
 CONFIG_ATL1C=y
 CONFIG_KS8851=y
+CONFIG_SMSC911X=y
 CONFIG_MDIO_BITBANG=y
 CONFIG_MDIO_GPIO=y
 CONFIG_SLIP=y
@@ -165,6 +167,12 @@ CONFIG_MMC_QCOM_DML=y
 CONFIG_MMC_SDHCI=y
 CONFIG_MMC_SDHCI_PLTFM=y
 CONFIG_MMC_SDHCI_MSM=y
+CONFIG_NEW_LEDS=y
+CONFIG_LEDS_CLASS=y
+CONFIG_LEDS_GPIO=y
+CONFIG_LEDS_PM8058=y
+CONFIG_LEDS_TRIGGERS=y
+CONFIG_LEDS_TRIGGER_HEARTBEAT=y
 CONFIG_RTC_CLASS=y
 CONFIG_RTC_DRV_PM8XXX=y
 CONFIG_DMADEVICES=y
@@ -187,6 +195,14 @@ CONFIG_QCOM_PM=y
 CONFIG_QCOM_SMEM=y
 CONFIG_QCOM_SMD=y
 CONFIG_QCOM_SMD_RPM=y
+CONFIG_IIO=y
+CONFIG_IIO_BUFFER_CB=y
+CONFIG_IIO_SW_TRIGGER=y
+CONFIG_KXSD9=y
+CONFIG_MPU3050_I2C=y
+CONFIG_AK8975=y
+CONFIG_IIO_HRTIMER_TRIGGER=y
+CONFIG_BMP280=y
 CONFIG_PHY_QCOM_APQ8064_SATA=y
 CONFIG_PHY_QCOM_IPQ806X_SATA=y
 CONFIG_NVMEM=y