Commit f271b2cc authored by Max Krasnyansky's avatar Max Krasnyansky Committed by David S. Miller

tun: Fix/rewrite packet filtering logic

Please see the following thread to get some context on this
	http://marc.info/?l=linux-netdev&m=121564433018903&w=2

Basically the issue is that current multi-cast filtering stuff in
the TUN/TAP driver is seriously broken.
Original patch went in without proper review and ACK. It was broken and
confusing to start with and subsequent patches broke it completely.
To give you an idea of what's broken here are some of the issues:

- Very confusing comments throughout the code that imply that the
character device is a network interface in its own right, and that packets
are passed between the two nics. Which is completely wrong.

- Wrong set of ioctls is used for setting up filters. They look like
shortcuts for manipulating state of the tun/tap network interface but
in reality manipulate the state of the TX filter.

- ioctls that were originally used for setting address of the the TX filter
got "fixed" and now set the address of the network interface itself. Which
made filter totaly useless.

- Filtering is done too late. Instead of filtering early on, to avoid
unnecessary wakeups, filtering is done in the read() call.

The list goes on and on :)

So the patch cleans all that up. It introduces simple and clean interface for
setting up TX filters (TUNSETTXFILTER + tun_filter spec) and does filtering
before enqueuing the packets.

TX filtering is useful in the scenarios where TAP is part of a bridge, in
which case it gets all broadcast, multicast and potentially other packets when
the bridge is learning. So for example Ethernet tunnelling app may want to
setup TX filters to avoid tunnelling multicast traffic. QEMU and other
hypervisors can push RX filtering that is currently done in the guest into the
host context therefore saving wakeups and unnecessary data transfer.
Signed-off-by: default avatarMax Krasnyansky <maxk@qualcomm.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 89146504
This diff is collapsed.
......@@ -17,6 +17,7 @@
#define __IF_TUN_H
#include <linux/types.h>
#include <linux/if_ether.h>
/* Read queue size */
#define TUN_READQ_SIZE 500
......@@ -43,6 +44,7 @@
#define TUNSETGROUP _IOW('T', 206, int)
#define TUNGETFEATURES _IOR('T', 207, unsigned int)
#define TUNSETOFFLOAD _IOW('T', 208, unsigned int)
#define TUNSETTXFILTER _IOW('T', 209, unsigned int)
/* TUNSETIFF ifr flags */
#define IFF_TUN 0x0001
......@@ -57,10 +59,26 @@
#define TUN_F_TSO6 0x04 /* I can handle TSO for IPv6 packets */
#define TUN_F_TSO_ECN 0x08 /* I can handle TSO with ECN bits. */
/* Protocol info prepended to the packets (when IFF_NO_PI is not set) */
#define TUN_PKT_STRIP 0x0001
struct tun_pi {
unsigned short flags;
__u16 flags;
__be16 proto;
};
#define TUN_PKT_STRIP 0x0001
/*
* Filter spec (used for SETXXFILTER ioctls)
* This stuff is applicable only to the TAP (Ethernet) devices.
* If the count is zero the filter is disabled and the driver accepts
* all packets (promisc mode).
* If the filter is enabled in order to accept broadcast packets
* broadcast addr must be explicitly included in the addr list.
*/
#define TUN_FLT_ALLMULTI 0x0001 /* Accept all multicast packets */
struct tun_filter {
__u16 flags; /* TUN_FLT_ flags see above */
__u16 count; /* Number of addresses */
__u8 addr[0][ETH_ALEN];
};
#endif /* __IF_TUN_H */
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment