igc: Remove checking media type during MAC initialization

i225 device support only copper mode.
There is no point to check media type in the
igc_config_fc_after_link_up() method.
Signed-off-by: Sasha Neftin <sasha.neftin@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/igc/igc_mac.c

@@ -468,10 +468,8 @@ s32 igc_config_fc_after_link_up(struct igc_hw *hw)
 	 * so we had to force link.  In this case, we need to force the
 	 * configuration of the MAC to match the "fc" parameter.
 	 */
-	if (mac->autoneg_failed) {
-		if (hw->phy.media_type == igc_media_type_copper)
+	if (mac->autoneg_failed)
 		ret_val = igc_force_mac_fc(hw);
-	}
 
 	if (ret_val) {
 		hw_dbg("Error forcing flow control settings\n");
@@ -483,7 +481,7 @@ s32 igc_config_fc_after_link_up(struct igc_hw *hw)
 	 * has completed, and if so, how the PHY and link partner has
 	 * flow control configured.
 	 */
-	if (hw->phy.media_type == igc_media_type_copper && mac->autoneg) {
+	if (mac->autoneg) {
 		/* Read the MII Status Register and check to see if AutoNeg
 		 * has completed.  We read this twice because this reg has
 		 * some "sticky" (latched) bits.