drm/bridge: anx7625: add MIPI DPI input feature

The basic anx7625 driver only support MIPI DSI rx signal input.
This patch add MIPI DPI rx input configuration support, after apply
this patch, the driver can support DSI rx or DPI rx by adding
'bus-type' in DT.
Reviewed-by: Robert Foss <robert.foss@linaro.org>
Signed-off-by: Xin Ji <xji@analogixsemi.com>
Signed-off-by: Robert Foss <robert.foss@linaro.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20211104033639.2634502-1-xji@analogixsemi.com

drivers/gpu/drm/bridge/analogix/anx7625.h

@@ -141,6 +141,14 @@
 #define  HORIZONTAL_BACK_PORCH_H      0x22  /* Bit[7:4] are reserved */
 
 /******** END of I2C Address 0x72 *********/
+
+/***************************************************************/
+/* Register definition of device address 0x7a */
+#define DP_TX_SWING_REG_CNT		0x14
+#define DP_TX_LANE0_SWING_REG0		0x00
+#define DP_TX_LANE1_SWING_REG0		0x14
+/******** END of I2C Address 0x7a *********/
+
 /***************************************************************/
 /* Register definition of device address 0x7e */
 
@@ -349,12 +357,20 @@ struct s_edid_data {
 
 /***************** Display End *****************/
 
+#define MAX_LANES_SUPPORT	4
+
 struct anx7625_platform_data {
 	struct gpio_desc *gpio_p_on;
 	struct gpio_desc *gpio_reset;
 	struct regulator_bulk_data supplies[3];
 	struct drm_bridge *panel_bridge;
 	int intp_irq;
+	int is_dpi;
+	int mipi_lanes;
+	int dp_lane0_swing_reg_cnt;
+	int lane0_reg_data[DP_TX_SWING_REG_CNT];
+	int dp_lane1_swing_reg_cnt;
+	int lane1_reg_data[DP_TX_SWING_REG_CNT];
 	u32 low_power_mode;
 	struct device_node *mipi_host_node;
 };