doc: dt: mtd: support partitions in a special 'partitions' subnode

To avoid conflict with other drivers using subnodes of the mtd device
create only one ofpart-specific node rather than any number of
arbitrary partition subnodes.
Signed-off-by: Michal Suchanek <hramrach@gmail.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Brian Norris <computersforpeace@gmail.com>

Documentation/devicetree/bindings/mtd/partition.txt

@@ -4,10 +4,17 @@ Partitions can be represented by sub-nodes of an mtd device. This can be used
 on platforms which have strong conventions about which portions of a flash are
 used for what purposes, but which don't use an on-flash partition table such
 as RedBoot.
-NOTE: if the sub-node has a compatible string, then it is not a partition.
 
-#address-cells & #size-cells must both be present in the mtd device. There are
-two valid values for both:
+The partition table should be a subnode of the mtd node and should be named
+'partitions'. Partitions are defined in subnodes of the partitions node.
+
+For backwards compatibility partitions as direct subnodes of the mtd device are
+supported. This use is discouraged.
+NOTE: also for backwards compatibility, direct subnodes that have a compatible
+string are not considered partitions, as they may be used for other bindings.
+
+#address-cells & #size-cells must both be present in the partitions subnode of the
+mtd device. There are two valid values for both:
 <1>: for partitions that require a single 32-bit cell to represent their
      size/address (aka the value is below 4 GiB)
 <2>: for partitions that require two 32-bit cells to represent their
@@ -28,6 +35,7 @@ Examples:
 
 
 flash@0 {
+	partitions {
 		#address-cells = <1>;
 		#size-cells = <1>;
 
@@ -40,9 +48,11 @@ flash@0 {
 		uimage@100000 {
 			reg = <0x0100000 0x200000>;
 		};
+	};
 };
 
 flash@1 {
+	partitions {
 		#address-cells = <1>;
 		#size-cells = <2>;
 
@@ -51,9 +61,11 @@ flash@1 {
 			label = "filesystem";
 			reg = <0x00000000 0x1 0x00000000>;
 		};
+	};
 };
 
 flash@2 {
+	partitions {
 		#address-cells = <2>;
 		#size-cells = <2>;
 
@@ -68,4 +80,5 @@ flash@2 {
 			label = "filesystem #2";
 			reg = <0x2 0x00000000 0x1 0x00000000>;
 		};
+	};
 };