• Mathias Krause's avatar
    crypto: sha1 - SSSE3 based SHA1 implementation for x86-64 · 66be8951
    Mathias Krause authored
    This is an assembler implementation of the SHA1 algorithm using the
    Supplemental SSE3 (SSSE3) instructions or, when available, the
    Advanced Vector Extensions (AVX).
    
    Testing with the tcrypt module shows the raw hash performance is up to
    2.3 times faster than the C implementation, using 8k data blocks on a
    Core 2 Duo T5500. For the smalest data set (16 byte) it is still 25%
    faster.
    
    Since this implementation uses SSE/YMM registers it cannot safely be
    used in every situation, e.g. while an IRQ interrupts a kernel thread.
    The implementation falls back to the generic SHA1 variant, if using
    the SSE/YMM registers is not possible.
    
    With this algorithm I was able to increase the throughput of a single
    IPsec link from 344 Mbit/s to 464 Mbit/s on a Core 2 Quad CPU using
    the SSSE3 variant -- a speedup of +34.8%.
    
    Saving and restoring SSE/YMM state might make the actual throughput
    fluctuate when there are FPU intensive userland applications running.
    For example, meassuring the performance using iperf2 directly on the
    machine under test gives wobbling numbers because iperf2 uses the FPU
    for each packet to check if the reporting interval has expired (in the
    above test I got min/max/avg: 402/484/464 MBit/s).
    
    Using this algorithm on a IPsec gateway gives much more reasonable and
    stable numbers, albeit not as high as in the directly connected case.
    Here is the result from an RFC 2544 test run with a EXFO Packet Blazer
    FTB-8510:
    
     frame size    sha1-generic     sha1-ssse3    delta
        64 byte     37.5 MBit/s    37.5 MBit/s     0.0%
       128 byte     56.3 MBit/s    62.5 MBit/s   +11.0%
       256 byte     87.5 MBit/s   100.0 MBit/s   +14.3%
       512 byte    131.3 MBit/s   150.0 MBit/s   +14.2%
      1024 byte    162.5 MBit/s   193.8 MBit/s   +19.3%
      1280 byte    175.0 MBit/s   212.5 MBit/s   +21.4%
      1420 byte    175.0 MBit/s   218.7 MBit/s   +25.0%
      1518 byte    150.0 MBit/s   181.2 MBit/s   +20.8%
    
    The throughput for the largest frame size is lower than for the
    previous size because the IP packets need to be fragmented in this
    case to make there way through the IPsec tunnel.
    Signed-off-by: default avatarMathias Krause <minipli@googlemail.com>
    Cc: Maxim Locktyukhin <maxim.locktyukhin@intel.com>
    Signed-off-by: default avatarHerbert Xu <herbert@gondor.apana.org.au>
    66be8951
Kconfig 24.4 KB