• Michal Kazior's avatar
    ath10k: allow loading device specific board files · de57e2c8
    Michal Kazior authored
    Some devices differ slightly and require different
    board files. If wrong board data is used they
    crash or behave incorrectly.
    
    These devices can be differentiated by looking at
    PCI subsystem device id. That is the case for
    qca61x4 devices at least.
    
    The board specific filename is constructed as:
    
     board-<bus>-<id>.bin
    
    For PCI in particular it is:
    
     board-pci-<vendor>:<dev>:<subsys_vendor>:<subsys_dev>.bin
    
    These files are looked in device/hw specific
    directories. Hence for Killer 1525 (qca6174 hw2.1)
    ath10k will request:
    
      /lib/firmware/ath10k/QCA6174/hw2.1/board-pci-168c:003e:1a56:1525.bin
    
    To not break any existing setups (e.g. in case
    some devices in the wild already have subsys ids)
    if a board specific file isn't found a generic one
    is used which is the one which would be used until
    now. This guarantees that after upgrading a driver
    device will not suddenly stop working due to
    now-missing specific board file. If this is the
    case a "fallback" string is appended to the info
    string when driver boots.
    
    Keep in mind this is distinct from cal-pci-*.bin
    files which contain full calibration data and MAC
    address. Cal data is aimed at systems where
    calibration data is stored out of band, e.g. on
    nand flash instead of device EEPROM - an approach
    taken by some AP/router vendors.
    
    Board files are more of a template and needs some
    bits to be filled in by the OTP program using
    device EEPROM contents.
    
    One could argue to map subsystem ids to some board
    design codename strings instead of using raw ids
    when building the board filename. Using a mapping
    however would make it a lot more cumbersome and
    time consuming (due to how patches propagate over
    various kernel trees) to add support for some new
    device board designs. Adding a board file is a lot
    quicker and doesn't require recompilation.
    Signed-off-by: default avatarMichal Kazior <michal.kazior@tieto.com>
    Signed-off-by: default avatarKalle Valo <kvalo@qca.qualcomm.com>
    de57e2c8
debug.c 57.5 KB