• Phil Sutter's avatar
    Input: add driver for S1 button of rb532 · d9bdffd2
    Phil Sutter authored
    Mikrotik's Routerboard 532 has two builtin buttons, from which one
    triggers a hardware reset. The other one is accessible through GPIO
    pin 1. Sadly, this pin is being multiplexed with UART0 input, so
    enabling it as interrupt source (as implied by the gpio-keys driver)
    is not possible unless UART0 has been turned off. The later one though
    is a rather bad idea as the Routerboard is an embedded device with
    only a single serial port, so it's almost always used as serial
    console device.
    
    This patch adds a driver based on INPUT_POLLDEV, which disables the
    UART and reconfigures GPIO pin 1 temporarily while reading the button
    state.  This procedure works fine and has been tested as part of
    another, unpublished driver for this device.
    Signed-off-by: default avatarPhil Sutter <n0-1@freewrt.org>
    Signed-off-by: default avatarDmitry Torokhov <dtor@mail.ru>
    d9bdffd2
Makefile 1.02 KB