Commit 00e70bad authored by Thomas Gleixner's avatar Thomas Gleixner

powerpc: cell: Fix the irq_desc access

The core irq_set_type() function updates the flow type when the chip
callback returns 0. It also updates irq_data, so this can be used in
irq_ack() to check for the level bit. That avoids a redundant sparse
irq lookup.
Signed-off-by: default avatarThomas Gleixner <tglx@linutronix.de>
parent 8c99f561
......@@ -102,7 +102,7 @@ static void spider_ack_irq(struct irq_data *d)
/* Reset edge detection logic if necessary
*/
if (irq_to_desc(d->irq)->status & IRQ_LEVEL)
if (irqd_is_level_type(d))
return;
/* Only interrupts 47 to 50 can be set to edge */
......@@ -119,7 +119,6 @@ static int spider_set_irq_type(struct irq_data *d, unsigned int type)
struct spider_pic *pic = spider_virq_to_pic(d->irq);
unsigned int hw = irq_map[d->irq].hwirq;
void __iomem *cfg = spider_get_irq_config(pic, hw);
struct irq_desc *desc = irq_to_desc(d->irq);
u32 old_mask;
u32 ic;
......@@ -147,12 +146,6 @@ static int spider_set_irq_type(struct irq_data *d, unsigned int type)
return -EINVAL;
}
/* Update irq_desc */
desc->status &= ~(IRQ_TYPE_SENSE_MASK | IRQ_LEVEL);
desc->status |= type & IRQ_TYPE_SENSE_MASK;
if (type & (IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_LEVEL_LOW))
desc->status |= IRQ_LEVEL;
/* Configure the source. One gross hack that was there before and
* that I've kept around is the priority to the BE which I set to
* be the same as the interrupt source number. I don't know wether
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment