net/fsl: remove hardcoded clock setting from xgmac_mdio

There is no need to set the clock speed in read/write which will be performed
unnecessarily for each mdio access. Init it during probe is enough.

Also, the hardcoded clock value is not a proper way for all SoCs.
Signed-off-by: Shaohui Xie <Shaohui.Xie@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/freescale/xgmac_mdio.c

@@ -94,13 +94,6 @@ static int xgmac_mdio_write(struct mii_bus *bus, int phy_id, int regnum, u16 val
 	uint16_t dev_addr = regnum >> 16;
 	int ret;
 
-	/* Setup the MII Mgmt clock speed */
-	out_be32(&regs->mdio_stat, MDIO_STAT_CLKDIV(100));
-
-	ret = xgmac_wait_until_free(&bus->dev, regs);
-	if (ret)
-		return ret;
-
 	/* Set the port and dev addr */
 	out_be32(&regs->mdio_ctl,
 		 MDIO_CTL_PORT_ADDR(phy_id) | MDIO_CTL_DEV_ADDR(dev_addr));
@@ -135,13 +128,6 @@ static int xgmac_mdio_read(struct mii_bus *bus, int phy_id, int regnum)
 	uint16_t value;
 	int ret;
 
-	/* Setup the MII Mgmt clock speed */
-	out_be32(&regs->mdio_stat, MDIO_STAT_CLKDIV(100));
-
-	ret = xgmac_wait_until_free(&bus->dev, regs);
-	if (ret)
-		return ret;
-
 	/* Set the Port and Device Addrs */
 	mdio_ctl = MDIO_CTL_PORT_ADDR(phy_id) | MDIO_CTL_DEV_ADDR(dev_addr);
 	out_be32(&regs->mdio_ctl, mdio_ctl);