Commit 06597aa9 authored by Martyn Welch's avatar Martyn Welch Committed by Kumar Gala

powerpc: Use generic PHY driver for Marvell 88E1111 PHY on GE Fanuc SBC610

The Marvell PHY driver is currently being used for the 88E1111 on the
SBC610. This driver is causing the link to run in 10/Half mode, the generic
PHY driver is correctly configuring the PHY as 1000/Full.

Edit default config to use generic PHY driver.
Signed-off-by: default avatarMartyn Welch <martyn.welch@gefanuc.com>
Signed-off-by: default avatarKumar Gala <galak@kernel.crashing.org>
parent f464ff58
...@@ -838,7 +838,7 @@ CONFIG_PHYLIB=y ...@@ -838,7 +838,7 @@ CONFIG_PHYLIB=y
# #
# MII PHY device drivers # MII PHY device drivers
# #
CONFIG_MARVELL_PHY=y # CONFIG_MARVELL_PHY is not set
# CONFIG_DAVICOM_PHY is not set # CONFIG_DAVICOM_PHY is not set
# CONFIG_QSEMI_PHY is not set # CONFIG_QSEMI_PHY is not set
# CONFIG_LXT_PHY is not set # CONFIG_LXT_PHY is not set
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment