ARM: 6499/1: Thumb-2: Correct data alignment for CONFIG_THUMB2_KERNEL in bootp/init.S

Directives such as .long and .word do not magically cause the
assembler location counter to become aligned in gas.  As a result,
using these directives in code sections can result in misaligned
data words when building a Thumb-2 kernel (CONFIG_THUMB2_KERNEL).

This is a Bad Thing, since the ABI permits the compiler to assume
that fundamental types of word size or above are word- aligned when
accessing them from C.  If the data is not really word-aligned,
this can cause impaired performance and stray alignment faults in
some circumstances.

In general, the following rules should be applied when using data
word declaration directives inside code sections:

    * .quad and .double:
         .align 3

    * .long, .word, .single, .float:
         .align (or .align 2)

    * .short:
        No explicit alignment required, since Thumb-2
        instructions are always 2 or 4 bytes in size.
        immediately after an instruction.
Reviewed-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Dave Martin <dave.martin@linaro.org>
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

arch/arm/boot/bootp/init.S

@@ -73,6 +73,8 @@ move:		ldmia	r4!, {r7 - r10}		@ move 32-bytes at a time
 
 		.size	_start, . - _start
 
+		.align
+
 		.type	data,#object
 data:		.word	initrd_start		@ source initrd address
 		.word	initrd_phys		@ destination initrd address