ASoC: rt1011: Add a flag for the R0 calibration test

The factory test needs to know whether the calibration completed.
This flag helps to confirm the calibration completed or not.
Signed-off-by: Shuming Fan <shumingf@realtek.com>
Link: https://lore.kernel.org/r/20190806091459.14382-1-shumingf@realtek.comSigned-off-by: Mark Brown <broonie@kernel.org>

sound/soc/codecs/rt1011.c

@@ -1225,7 +1225,10 @@ static int rt1011_bq_drc_info(struct snd_kcontrol *kcontrol,
 static int rt1011_r0_cali_get(struct snd_kcontrol *kcontrol,
 		struct snd_ctl_elem_value *ucontrol)
 {
-	ucontrol->value.integer.value[0] = 0;
+	struct snd_soc_component *component = snd_kcontrol_chip(kcontrol);
+	struct rt1011_priv *rt1011 = snd_soc_component_get_drvdata(component);
+
+	ucontrol->value.integer.value[0] = rt1011->cali_done;
 
 	return 0;
 }
@@ -1239,6 +1242,7 @@ static int rt1011_r0_cali_put(struct snd_kcontrol *kcontrol,
 	if (!component->card->instantiated)
 		return 0;
 
+	rt1011->cali_done = 0;
 	if (snd_soc_component_get_bias_level(component) == SND_SOC_BIAS_OFF &&
 		ucontrol->value.integer.value[0])
 		rt1011_calibrate(rt1011, 1);
@@ -2135,6 +2139,7 @@ static int rt1011_calibrate(struct rt1011_priv *rt1011, unsigned char cali_flag)
 			r0_factor = ((format / r0[0] * 100) / 128)
 							- (r0_integer * 100);
 			rt1011->r0_reg = r0[0];
+			rt1011->cali_done = 1;
 			dev_info(dev,	"r0 resistance about %d.%02d ohm, reg=0x%X\n",
 				r0_integer, r0_factor, r0[0]);
 		}
@@ -2185,6 +2190,13 @@ static void rt1011_calibration_work(struct work_struct *work)
 
 	rt1011_calibrate(rt1011, 1);
 
+	/*
+	 * This flag should reset after booting.
+	 * The factory test will do calibration again and use this flag to check
+	 * whether the calibration completed
+	 */
+	rt1011->cali_done = 0;
+
 	/* initial */
 	rt1011_reg_init(component);
 }

sound/soc/codecs/rt1011.h

@@ -666,7 +666,7 @@ struct rt1011_priv {
 	int pll_out;
 
 	int bq_drc_set;
-	unsigned int r0_reg;
+	unsigned int r0_reg, cali_done;
 	int recv_spk_mode;
 };