Blackfin arch: add support for the BlackStamp board

Signed-off-by: Benjamin Matthews <bmat@lle.rochester.edu>
Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>

arch/blackfin/Kconfig

@@ -249,7 +249,7 @@ config MEM_MT48LC8M32B2B5_7
 
 config MEM_MT48LC32M16A2TG_75
 	bool
-	depends on (BFIN527_EZKIT || BFIN532_IP0X)
+	depends on (BFIN527_EZKIT || BFIN532_IP0X || BLACKSTAMP)
 	default y
 
 source "arch/blackfin/mach-bf527/Kconfig"
@@ -292,7 +292,7 @@ config CLKIN_HZ
 	int "Frequency of the crystal on the board in Hz"
 	default "11059200" if BFIN533_STAMP
 	default "27000000" if BFIN533_EZKIT
-	default "25000000" if (BFIN537_STAMP || BFIN527_EZKIT || H8606_HVSISTEMAS)
+	default "25000000" if (BFIN537_STAMP || BFIN527_EZKIT || H8606_HVSISTEMAS || BLACKSTAMP)
 	default "30000000" if BFIN561_EZKIT
 	default "24576000" if PNAV10
 	default "10000000" if BFIN532_IP0X
@@ -332,7 +332,7 @@ config VCO_MULT
 	default "22" if BFIN533_BLUETECHNIX_CM
 	default "20" if (BFIN537_BLUETECHNIX_CM || BFIN527_BLUETECHNIX_CM || BFIN561_BLUETECHNIX_CM)
 	default "20" if BFIN561_EZKIT
-	default "16" if H8606_HVSISTEMAS
+	default "16" if (H8606_HVSISTEMAS || BLACKSTAMP)
 	help
 	  This controls the frequency of the on-chip PLL. This can be between 1 and 64.
 	  PLL Frequency = (Crystal Frequency) * (this setting)

arch/blackfin/mach-bf533/boards/Kconfig

@@ -14,6 +14,12 @@ config BFIN533_STAMP
 	help
 	  BF533-STAMP board support.
 
+config BLACKSTAMP
+	bool "BlackStamp"
+	help
+	  Support for the BlackStamp board.  Hardware info available at
+	  http://blackfin.uclinux.org/gf/project/blackstamp/
+
 config BFIN533_BLUETECHNIX_CM
 	bool "Bluetechnix CM-BF533"
 	depends on (BF533)

arch/blackfin/mach-bf533/boards/Makefile

@@ -7,4 +7,5 @@ obj-$(CONFIG_BFIN533_STAMP)            += stamp.o
 obj-$(CONFIG_BFIN532_IP0X)             += ip0x.o
 obj-$(CONFIG_BFIN533_EZKIT)            += ezkit.o
 obj-$(CONFIG_BFIN533_BLUETECHNIX_CM)   += cm_bf533.o
+obj-$(CONFIG_BLACKSTAMP)               += blackstamp.o
 obj-$(CONFIG_H8606_HVSISTEMAS)         += H8606.o