Commit 1984e075 authored by Marc Zyngier's avatar Marc Zyngier Committed by Thomas Gleixner

genirq: Skip chained interrupt trigger setup if type is IRQ_TYPE_NONE

There is no point in trying to configure the trigger of a chained
interrupt if no trigger information has been configured. At best
this is ignored, and at the worse this confuses the underlying
irqchip (which is likely not to handle such a thing), and
unnecessarily alarms the user.

Only apply the configuration if type is not IRQ_TYPE_NONE.

Fixes: 1e12c4a9 ("genirq: Correctly configure the trigger on chained interrupts")
Reported-and-tested-by: default avatarGeert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: default avatarMarc Zyngier <marc.zyngier@arm.com>
Link: https://lkml.kernel.org/r/CAMuHMdVW1eTn20=EtYcJ8hkVwohaSuH_yQXrY2MGBEvZ8fpFOg@mail.gmail.com
Link: http://lkml.kernel.org/r/1474274967-15984-1-git-send-email-marc.zyngier@arm.comSigned-off-by: default avatarThomas Gleixner <tglx@linutronix.de>
parent 3be79886
......@@ -820,6 +820,8 @@ __irq_do_set_handler(struct irq_desc *desc, irq_flow_handler_t handle,
desc->name = name;
if (handle != handle_bad_irq && is_chained) {
unsigned int type = irqd_get_trigger_type(&desc->irq_data);
/*
* We're about to start this interrupt immediately,
* hence the need to set the trigger configuration.
......@@ -828,8 +830,10 @@ __irq_do_set_handler(struct irq_desc *desc, irq_flow_handler_t handle,
* chained interrupt. Reset it immediately because we
* do know better.
*/
__irq_set_trigger(desc, irqd_get_trigger_type(&desc->irq_data));
desc->handle_irq = handle;
if (type != IRQ_TYPE_NONE) {
__irq_set_trigger(desc, type);
desc->handle_irq = handle;
}
irq_settings_set_noprobe(desc);
irq_settings_set_norequest(desc);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment