Commit 19a2ee69 authored by H. Nikolaus Schaller's avatar H. Nikolaus Schaller Committed by Sebastian Reichel

power: supply: twl4030-charger: don't check if battery is present

We can't assume that the battery is or stays present after probing
on devices with replaceable battery.

On some devices (e.g. GTA04 or OpenPanodra) it can be removed
and even be hot swapped by the user while device continues to operate
through external AC or USB power (as long as system power consumption
remains below ca. 500mA as provided by USB). Under certain conditions
it is possible to boot without battery.

So it makes no sense to check for this situation during probe and make
the charger driver (and its status reports) completely non-operational if
the battery can be inserted later.

Tested on: GTA04 and OpenPandora.
Signed-off-by: default avatarH. Nikolaus Schaller <hns@goldelico.com>
Signed-off-by: default avatarSebastian Reichel <sebastian.reichel@collabora.co.uk>
parent 3fb319c2
...@@ -205,35 +205,6 @@ static int twl4030bci_read_adc_val(u8 reg) ...@@ -205,35 +205,6 @@ static int twl4030bci_read_adc_val(u8 reg)
return temp | val; return temp | val;
} }
/*
* Check if Battery Pack was present
*/
static int twl4030_is_battery_present(struct twl4030_bci *bci)
{
int ret;
u8 val = 0;
/* Battery presence in Main charge? */
ret = twl_i2c_read_u8(TWL_MODULE_MAIN_CHARGE, &val, TWL4030_BCIMFSTS3);
if (ret)
return ret;
if (val & TWL4030_BATSTSMCHG)
return 0;
/*
* OK, It could be that bootloader did not enable main charger,
* pre-charge is h/w auto. So, Battery presence in Pre-charge?
*/
ret = twl_i2c_read_u8(TWL4030_MODULE_PRECHARGE, &val,
TWL4030_BCIMFSTS1);
if (ret)
return ret;
if (val & TWL4030_BATSTSPCHG)
return 0;
return -ENODEV;
}
/* /*
* TI provided formulas: * TI provided formulas:
* CGAIN == 0: ICHG = (BCIICHG * 1.7) / (2^10 - 1) - 0.85 * CGAIN == 0: ICHG = (BCIICHG * 1.7) / (2^10 - 1) - 0.85
...@@ -1068,13 +1039,6 @@ static int twl4030_bci_probe(struct platform_device *pdev) ...@@ -1068,13 +1039,6 @@ static int twl4030_bci_probe(struct platform_device *pdev)
bci->irq_chg = platform_get_irq(pdev, 0); bci->irq_chg = platform_get_irq(pdev, 0);
bci->irq_bci = platform_get_irq(pdev, 1); bci->irq_bci = platform_get_irq(pdev, 1);
/* Only proceed further *IF* battery is physically present */
ret = twl4030_is_battery_present(bci);
if (ret) {
dev_crit(&pdev->dev, "Battery was not detected:%d\n", ret);
return ret;
}
platform_set_drvdata(pdev, bci); platform_set_drvdata(pdev, bci);
bci->ac = devm_power_supply_register(&pdev->dev, &twl4030_bci_ac_desc, bci->ac = devm_power_supply_register(&pdev->dev, &twl4030_bci_ac_desc,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment