ARM: dts: sun8i: a83t: Correct USB3503 GPIOs polarity

Current USB3503 driver ignores GPIO polarity and always operates as if the
GPIO lines were flagged as ACTIVE_HIGH. Fix the polarity for the existing
USB3503 chip applications to match the chip specification and common
convention for naming the pins. The only pin, which has to be ACTIVE_LOW
is the reset pin. The remaining are ACTIVE_HIGH. This change allows later
to fix the USB3503 driver to properly use generic GPIO bindings and read
polarity from DT.
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Maxime Ripard <maxime@cerno.tech>

arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts

@@ -101,7 +101,7 @@ usb-hub {
 		initial-mode = <1>; /* initialize in HUB mode */
 		disabled-ports = <1>;
 		intn-gpios = <&pio 7 5 GPIO_ACTIVE_HIGH>; /* PH5 */
-		reset-gpios = <&pio 4 16 GPIO_ACTIVE_HIGH>; /* PE16 */
+		reset-gpios = <&pio 4 16 GPIO_ACTIVE_LOW>; /* PE16 */
 		connect-gpios = <&pio 4 17 GPIO_ACTIVE_HIGH>; /* PE17 */
 		refclk-frequency = <19200000>;
 	};