[SCSI] qla2xxx: Enable the Flash Access Control (FAC) mailbox command.

Signed-off-by: Joe Carnuccio <joe.carnuccio@qlogic.com>
Signed-off-by: Saurav Kashyap <saurav.kashyap@qlogic.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>

drivers/scsi/qla2xxx/qla_init.c

@@ -1718,9 +1718,6 @@ qla2x00_setup_chip(scsi_qla_host_t *vha)
 		spin_unlock_irqrestore(&ha->hardware_lock, flags);
 	}
 
-	if (IS_QLA83XX(ha))
-		goto skip_fac_check;
-
 	if (rval == QLA_SUCCESS && IS_FAC_REQUIRED(ha)) {
 		uint32_t size;
 
@@ -1733,7 +1730,7 @@ qla2x00_setup_chip(scsi_qla_host_t *vha)
 			    "Unsupported FAC firmware (%d.%02d.%02d).\n",
 			    ha->fw_major_version, ha->fw_minor_version,
 			    ha->fw_subminor_version);
-skip_fac_check:
+
 			if (IS_QLA83XX(ha)) {
 				ha->flags.fac_supported = 0;
 				rval = QLA_SUCCESS;