phy: ti-pipe3: Fix PCIe power up sequence

TRM [1] mentions that we need to power up
PCIESS_PHY_TX and PCIESS_PHY_RX before configuring
PCIe_PHY_RX SCP settings.

See "Table 26-81. PCIePHY Subsystem Low-Level Programming Sequence".

[1] DRA75x, DRA74x TRM - http://www.ti.com/lit/ug/sprui30f/sprui30f.pdfSigned-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>

drivers/phy/ti/phy-ti-pipe3.c

@@ -341,6 +341,8 @@ static int ti_pipe3_power_off(struct phy *x)
 	return ret;
 }
 
+static void ti_pipe3_calibrate(struct ti_pipe3 *phy);
+
 static int ti_pipe3_power_on(struct phy *x)
 {
 	u32 val;
@@ -386,6 +388,9 @@ static int ti_pipe3_power_on(struct phy *x)
 				   mask, val);
 	}
 
+	if (phy->mode == PIPE3_MODE_PCIE)
+		ti_pipe3_calibrate(phy);
+
 	return 0;
 }
 
@@ -520,12 +525,7 @@ static int ti_pipe3_init(struct phy *x)
 		val = 0x96 << OMAP_CTRL_PCIE_PCS_DELAY_COUNT_SHIFT;
 		ret = regmap_update_bits(phy->pcs_syscon, phy->pcie_pcs_reg,
 					 PCIE_PCS_MASK, val);
-		if (ret)
-			return ret;
-
-		ti_pipe3_calibrate(phy);
-
-		return 0;
+		return ret;
 	}
 
 	/* Bring it out of IDLE if it is IDLE */