Commit 201cd6cc authored by Sujith's avatar Sujith Committed by John W. Linville

ath9k: Remove a few unused functions

ATH9K_ANT_VARIABLE is the default diversity control used.
Consequently ath9k_hw_decrease_chain_power() does nothing.
ath9k_hw_setantennaswitch() is unused too.

Also, gbeacon_rate is unused.
Signed-off-by: default avatarSujith <Sujith.Manoharan@atheros.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent 7c82a186
......@@ -390,8 +390,6 @@ static void ath9k_hw_init_config(struct ath_hw *ah)
ah->config.cck_trig_high = 200;
ah->config.cck_trig_low = 100;
ah->config.enable_ani = 1;
ah->config.diversity_control = ATH9K_ANT_VARIABLE;
ah->config.antenna_switch_swap = 0;
for (i = 0; i < AR_EEPROM_MODAL_SPURS; i++) {
ah->config.spurchans[i][0] = AR_NO_SPUR;
......@@ -446,9 +444,6 @@ static void ath9k_hw_init_defaults(struct ath_hw *ah)
ah->acktimeout = (u32) -1;
ah->ctstimeout = (u32) -1;
ah->globaltxtimeout = (u32) -1;
ah->gbeacon_rate = 0;
ah->power_mode = ATH9K_PM_UNDEFINED;
}
......@@ -2056,9 +2051,6 @@ int ath9k_hw_reset(struct ath_hw *ah, struct ath9k_channel *chan,
ah->ath9k_hw_spur_mitigate_freq(ah, chan);
ah->eep_ops->set_board_values(ah, chan);
if (AR_SREV_5416(ah))
ath9k_hw_decrease_chain_power(ah, chan);
REG_WRITE(ah, AR_STA_ID0, get_unaligned_le32(common->macaddr));
REG_WRITE(ah, AR_STA_ID1, get_unaligned_le16(common->macaddr + 4)
| macStaId1
......@@ -3518,51 +3510,6 @@ void ath9k_hw_setantenna(struct ath_hw *ah, u32 antenna)
}
EXPORT_SYMBOL(ath9k_hw_setantenna);
bool ath9k_hw_setantennaswitch(struct ath_hw *ah,
enum ath9k_ant_setting settings,
struct ath9k_channel *chan,
u8 *tx_chainmask,
u8 *rx_chainmask,
u8 *antenna_cfgd)
{
static u8 tx_chainmask_cfg, rx_chainmask_cfg;
if (AR_SREV_9280(ah)) {
if (!tx_chainmask_cfg) {
tx_chainmask_cfg = *tx_chainmask;
rx_chainmask_cfg = *rx_chainmask;
}
switch (settings) {
case ATH9K_ANT_FIXED_A:
*tx_chainmask = ATH9K_ANTENNA0_CHAINMASK;
*rx_chainmask = ATH9K_ANTENNA0_CHAINMASK;
*antenna_cfgd = true;
break;
case ATH9K_ANT_FIXED_B:
if (ah->caps.tx_chainmask >
ATH9K_ANTENNA1_CHAINMASK) {
*tx_chainmask = ATH9K_ANTENNA1_CHAINMASK;
}
*rx_chainmask = ATH9K_ANTENNA1_CHAINMASK;
*antenna_cfgd = true;
break;
case ATH9K_ANT_VARIABLE:
*tx_chainmask = tx_chainmask_cfg;
*rx_chainmask = rx_chainmask_cfg;
*antenna_cfgd = true;
break;
default:
break;
}
} else {
ah->config.diversity_control = settings;
}
return true;
}
/*********************/
/* General Operation */
/*********************/
......
......@@ -148,21 +148,6 @@ enum wireless_mode {
ATH9K_MODE_MAX,
};
/**
* ath9k_ant_setting - transmit antenna settings
*
* Configures the antenna setting to use for transmit.
*
* @ATH9K_ANT_VARIABLE: this means transmit on all active antennas
* @ATH9K_ANT_FIXED_A: this means transmit on the first antenna only
* @ATH9K_ANT_FIXED_B: this means transmit on the second antenna only
*/
enum ath9k_ant_setting {
ATH9K_ANT_VARIABLE = 0,
ATH9K_ANT_FIXED_A,
ATH9K_ANT_FIXED_B
};
enum ath9k_hw_caps {
ATH9K_HW_CAP_MIC_AESCCM = BIT(0),
ATH9K_HW_CAP_MIC_CKIP = BIT(1),
......@@ -226,8 +211,6 @@ struct ath9k_ops_config {
u32 cck_trig_high;
u32 cck_trig_low;
u32 enable_ani;
enum ath9k_ant_setting diversity_control;
u16 antenna_switch_swap;
int serialize_regmode;
bool intr_mitigation;
#define SPUR_DISABLE 0
......@@ -572,7 +555,6 @@ struct ath_hw {
u32 acktimeout;
u32 ctstimeout;
u32 globaltxtimeout;
u8 gbeacon_rate;
/* ANI */
u32 proc_phyerr;
......@@ -659,11 +641,6 @@ void ath9k_hw_cfg_output(struct ath_hw *ah, u32 gpio,
void ath9k_hw_set_gpio(struct ath_hw *ah, u32 gpio, u32 val);
u32 ath9k_hw_getdefantenna(struct ath_hw *ah);
void ath9k_hw_setantenna(struct ath_hw *ah, u32 antenna);
bool ath9k_hw_setantennaswitch(struct ath_hw *ah,
enum ath9k_ant_setting settings,
struct ath9k_channel *chan,
u8 *tx_chainmask, u8 *rx_chainmask,
u8 *antenna_cfgd);
/* General Operation */
bool ath9k_hw_wait(struct ath_hw *ah, u32 reg, u32 mask, u32 val, u32 timeout);
......
......@@ -527,95 +527,6 @@ static void ath9k_hw_force_bias(struct ath_hw *ah, u16 synth_freq)
REG_WRITE_RF_ARRAY(&ah->iniBank6, ah->analogBank6Data, reg_writes);
}
/**
* ath9k_hw_decrease_chain_power()
*
* @ah: atheros hardware structure
* @chan:
*
* Only used on the AR5416 and AR5418 with the external AR2133/AR5133 radios.
*
* Sets a chain internal RF path to the lowest output power. Any
* further writes to bank6 after this setting will override these
* changes. Thus this function must be the last function in the
* sequence to modify bank 6.
*
* This function must be called after ar5416SetRfRegs() which is
* called from ath9k_hw_process_ini() due to swizzling of bank 6.
* Depends on ah->analogBank6Data being initialized by
* ath9k_hw_set_rf_regs()
*
* Additional additive reduction in power -
* change chain's switch table so chain's tx state is actually the rx
* state value. May produce different results in 2GHz/5GHz as well as
* board to board but in general should be a reduction.
*
* Activated by #ifdef ALTER_SWITCH. Not tried yet. If so, must be
* called after ah->eep_ops->set_board_values() due to RMW of
* PHY_SWITCH_CHAIN_0.
*/
void ath9k_hw_decrease_chain_power(struct ath_hw *ah,
struct ath9k_channel *chan)
{
int i, regWrites = 0;
u32 bank6SelMask;
u32 *bank6Temp = ah->bank6Temp;
BUG_ON(AR_SREV_9280_10_OR_LATER(ah));
switch (ah->config.diversity_control) {
case ATH9K_ANT_FIXED_A:
bank6SelMask =
(ah->config.antenna_switch_swap & ANTSWAP_AB) ?
REDUCE_CHAIN_0 : /* swapped, reduce chain 0 */
REDUCE_CHAIN_1; /* normal, select chain 1/2 to reduce */
break;
case ATH9K_ANT_FIXED_B:
bank6SelMask =
(ah->config.antenna_switch_swap & ANTSWAP_AB) ?
REDUCE_CHAIN_1 : /* swapped, reduce chain 1/2 */
REDUCE_CHAIN_0; /* normal, select chain 0 to reduce */
break;
case ATH9K_ANT_VARIABLE:
return; /* do not change anything */
break;
default:
return; /* do not change anything */
break;
}
for (i = 0; i < ah->iniBank6.ia_rows; i++)
bank6Temp[i] = ah->analogBank6Data[i];
/* Write Bank 5 to switch Bank 6 write to selected chain only */
REG_WRITE(ah, AR_PHY_BASE + 0xD8, bank6SelMask);
/*
* Modify Bank6 selected chain to use lowest amplification.
* Modifies the parameters to a value of 1.
* Depends on existing bank 6 values to be cached in
* ah->analogBank6Data
*/
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 189, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 190, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 191, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 192, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 193, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 222, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 245, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 246, 0);
ath9k_phy_modify_rx_buffer(bank6Temp, 1, 1, 247, 0);
REG_WRITE_RF_ARRAY(&ah->iniBank6, bank6Temp, regWrites);
REG_WRITE(ah, AR_PHY_BASE + 0xD8, 0x00000053);
#ifdef ALTER_SWITCH
REG_WRITE(ah, PHY_SWITCH_CHAIN_0,
(REG_READ(ah, PHY_SWITCH_CHAIN_0) & ~0x38)
| ((REG_READ(ah, PHY_SWITCH_CHAIN_0) >> 3) & 0x38));
#endif
}
/**
* ath9k_hw_set_channel - tune to a channel on the external AR2133/AR5133 radios
* @ah: atheros hardware stucture
......@@ -687,7 +598,6 @@ int ath9k_hw_set_channel(struct ath_hw *ah, struct ath9k_channel *chan)
}
ath9k_hw_force_bias(ah, freq);
ath9k_hw_decrease_chain_power(ah, chan);
reg32 =
(channelSel << 8) | (aModeRefSel << 2) | (bModeSynth << 1) |
......
......@@ -35,9 +35,6 @@ bool ath9k_hw_set_rf_regs(struct ath_hw *ah,
struct ath9k_channel *chan,
u16 modesIndex);
void ath9k_hw_decrease_chain_power(struct ath_hw *ah,
struct ath9k_channel *chan);
#define AR_PHY_BASE 0x9800
#define AR_PHY(_n) (AR_PHY_BASE + ((_n)<<2))
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment