Commit 2165c4a1 authored by Boris Brezillon's avatar Boris Brezillon

mtd: nand: Support 'EXIT GET STATUS' command in nand_command[_lp]()

READ0 is sometimes used to exit GET STATUS mode. When this is the case
no address cycles are requested, and we can use this information to
detect that READSTART should not be issued after READ0 or that we
shouldn't wait for the chip to be ready.
Signed-off-by: default avatarBoris Brezillon <boris.brezillon@free-electrons.com>
Tested-by: default avatarThomas Petazzoni <thomas.petazzoni@free-electrons.com>
parent 41145649
......@@ -753,6 +753,16 @@ static void nand_command(struct mtd_info *mtd, unsigned int command,
return;
/* This applies to read commands */
case NAND_CMD_READ0:
/*
* READ0 is sometimes used to exit GET STATUS mode. When this
* is the case no address cycles are requested, and we can use
* this information to detect that we should not wait for the
* device to be ready.
*/
if (column == -1 && page_addr == -1)
return;
default:
/*
* If we don't have access to the busy pin, we apply the given
......@@ -887,6 +897,15 @@ static void nand_command_lp(struct mtd_info *mtd, unsigned int command,
return;
case NAND_CMD_READ0:
/*
* READ0 is sometimes used to exit GET STATUS mode. When this
* is the case no address cycles are requested, and we can use
* this information to detect that READSTART should not be
* issued.
*/
if (column == -1 && page_addr == -1)
return;
chip->cmd_ctrl(mtd, NAND_CMD_READSTART,
NAND_NCE | NAND_CLE | NAND_CTRL_CHANGE);
chip->cmd_ctrl(mtd, NAND_CMD_NONE,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment