drm: Fix trivial typos in comments

Change 'pixes' to 'pixels'
Change 'enabel' to 'enable'
Change 'enabeling' to 'enabling'
Signed-off-by: Yannick Guerrini <yguerrini@tomshardware.fr>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>

drivers/gpu/drm/drm_modes.c

@@ -278,7 +278,7 @@ struct drm_display_mode *drm_cvt_mode(struct drm_device *dev, int hdisplay,
 		hblank = drm_mode->hdisplay * hblank_percentage /
 			 (100 * HV_FACTOR - hblank_percentage);
 		hblank -= hblank % (2 * CVT_H_GRANULARITY);
-		/* 14. find the total pixes per line */
+		/* 14. find the total pixels per line */
 		drm_mode->htotal = drm_mode->hdisplay + hblank;
 		drm_mode->hsync_end = drm_mode->hdisplay + hblank / 2;
 		drm_mode->hsync_start = drm_mode->hsync_end -
@@ -1209,7 +1209,7 @@ EXPORT_SYMBOL(drm_mode_connector_list_update);
  *	<xres>x<yres>[M][R][-<bpp>][@<refresh>][i][m][eDd]
  *
  * The intermediate drm_cmdline_mode structure is required to store additional
- * options from the command line modline like the force-enabel/disable flag.
+ * options from the command line modline like the force-enable/disable flag.
  *
  * Returns:
  * True if a valid modeline has been parsed, false otherwise.

drivers/gpu/drm/i2c/adv7511.c

@@ -573,7 +573,7 @@ static void adv7511_encoder_dpms(struct drm_encoder *encoder, int mode)
 		 * goes low the adv7511 is reset and the outputs are disabled
 		 * which might cause the monitor to go to standby again. To
 		 * avoid this we ignore the HDP pin for the first few seconds
-		 * after enabeling the output.
+		 * after enabling the output.
 		 */
 		regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER2,
 				   ADV7511_REG_POWER2_HDP_SRC_MASK,