mtd: nand: sunxi: fix EDO mode selection

The ONFI spec says that EDO should be enabled if the host drives tRC less
than 30ns, but the code just tests for the tRC_min value extracted from
the timings exposed by the NAND chip not the timings actually configured
in the NAND controller.
Fix that by first rounding down the requested clk_rate with
clk_round_rate() and then checking if tRC is actually smaller than 30ns.
Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>

drivers/mtd/nand/sunxi_nand.c

@@ -1100,6 +1100,7 @@ static int sunxi_nand_chip_set_timings(struct sunxi_nand_chip *chip,
 	struct sunxi_nfc *nfc = to_sunxi_nfc(chip->nand.controller);
 	u32 min_clk_period = 0;
 	s32 tWB, tADL, tWHR, tRHW, tCAD;
+	long real_clk_rate;
 
 	/* T1 <=> tCLS */
 	if (timings->tCLS_min > min_clk_period)
@@ -1197,13 +1198,6 @@ static int sunxi_nand_chip_set_timings(struct sunxi_nand_chip *chip,
 	/* TODO: A83 has some more bits for CDQSS, CS, CLHZ, CCS, WC */
 	chip->timing_cfg = NFC_TIMING_CFG(tWB, tADL, tWHR, tRHW, tCAD);
 
-	/*
-	 * ONFI specification 3.1, paragraph 4.15.2 dictates that EDO data
-	 * output cycle timings shall be used if the host drives tRC less than
-	 * 30 ns.
-	 */
-	chip->timing_ctl = (timings->tRC_min < 30000) ? NFC_TIMING_CTL_EDO : 0;
-
 	/* Convert min_clk_period from picoseconds to nanoseconds */
 	min_clk_period = DIV_ROUND_UP(min_clk_period, 1000);
 
@@ -1214,6 +1208,16 @@ static int sunxi_nand_chip_set_timings(struct sunxi_nand_chip *chip,
 	 * Allwinner engineers.
 	 */
 	chip->clk_rate = NSEC_PER_SEC / min_clk_period;
+	real_clk_rate = clk_round_rate(nfc->mod_clk, chip->clk_rate);
+
+	/*
+	 * ONFI specification 3.1, paragraph 4.15.2 dictates that EDO data
+	 * output cycle timings shall be used if the host drives tRC less than
+	 * 30 ns.
+	 */
+	min_clk_period = NSEC_PER_SEC / real_clk_rate;
+	chip->timing_ctl = ((min_clk_period * 2) < 30) ?
+			   NFC_TIMING_CTL_EDO : 0;
 
 	return 0;
 }