ARM: dts: am437x-gp-evm: Don't use read/write wait monitoring

NAND uses wait pin only to indicate device readiness after
a block/page operation. It is not use to extend individual
read/write cycle and so read/write wait pin monitoring must
be disabled for NAND.

This patch also gets rid of the below warning when NAND is
accessed for the first time.

omap_l3_noc 44000000.ocp: L3 application error: target 13 mod:1 (unclearable)
Signed-off-by: Roger Quadros <rogerq@ti.com>
Reviewed-by: Pekon Gupta <pekon@pek-sem.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/boot/dts/am437x-gp-evm.dts

@@ -443,8 +443,6 @@ nand@0,0 {
 		gpmc,rd-cycle-ns = <40>;
 		gpmc,wr-cycle-ns = <40>;
 		gpmc,wait-pin = <0>;
-		gpmc,wait-on-read;
-		gpmc,wait-on-write;
 		gpmc,bus-turnaround-ns = <0>;
 		gpmc,cycle2cycle-delay-ns = <0>;
 		gpmc,clk-activation-ns = <0>;