ath6kl: issue wmi disconnect after notifying cfg80211

ath6kl would issue a wmi disconnect command in response to a remote
disconnect and return early without notifying cfg80211, only sending a
cfg80211_disconnected (with reason code always 3) in response to the
second disconnect firmware event.

Pass the right reason code to cfg80211 on the first disconnect instead.

This fixes at least one bug where a p2p client would stop trying to
connect after receiving a stale RSN deauth which was reported to
cfg80211 as GO leaving BSS.
Signed-off-by: Thomas Pedersen <c_tpeder@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath6kl/cfg80211.c

@@ -860,20 +860,6 @@ void ath6kl_cfg80211_disconnect_event(struct ath6kl_vif *vif, u8 reason,
 		}
 	}
 
-	/*
-	 * Send a disconnect command to target when a disconnect event is
-	 * received with reason code other than 3 (DISCONNECT_CMD - disconnect
-	 * request from host) to make the firmware stop trying to connect even
-	 * after giving disconnect event. There will be one more disconnect
-	 * event for this disconnect command with reason code DISCONNECT_CMD
-	 * which will be notified to cfg80211.
-	 */
-
-	if (reason != DISCONNECT_CMD) {
-		ath6kl_wmi_disconnect_cmd(ar->wmi, vif->fw_vif_idx);
-		return;
-	}
-
 	clear_bit(CONNECT_PEND, &vif->flags);
 
 	if (vif->sme_state == SME_CONNECTING) {
@@ -883,11 +869,22 @@ void ath6kl_cfg80211_disconnect_event(struct ath6kl_vif *vif, u8 reason,
 					WLAN_STATUS_UNSPECIFIED_FAILURE,
 					GFP_KERNEL);
 	} else if (vif->sme_state == SME_CONNECTED) {
-		cfg80211_disconnected(vif->ndev, reason,
+		cfg80211_disconnected(vif->ndev, proto_reason,
 				      NULL, 0, GFP_KERNEL);
 	}
 
 	vif->sme_state = SME_DISCONNECTED;
+
+	/*
+	 * Send a disconnect command to target when a disconnect event is
+	 * received with reason code other than 3 (DISCONNECT_CMD - disconnect
+	 * request from host) to make the firmware stop trying to connect even
+	 * after giving disconnect event. There will be one more disconnect
+	 * event for this disconnect command with reason code DISCONNECT_CMD
+	 * which won't be notified to cfg80211.
+	 */
+	if (reason != DISCONNECT_CMD)
+		ath6kl_wmi_disconnect_cmd(ar->wmi, vif->fw_vif_idx);
 }
 
 static int ath6kl_set_probed_ssids(struct ath6kl *ar,