dt-bindings: Document the STM32 I2C bindings

This patch adds documentation of device tree bindings for the STM32 I2C
controller.
Signed-off-by: M'boumba Cedric Madianga <cedric.madianga@gmail.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

Documentation/devicetree/bindings/i2c/i2c-stm32.txt

+* I2C controller embedded in STMicroelectronics STM32 I2C platform
+
+Required properties :
+- compatible : Must be "st,stm32f4-i2c"
+- reg : Offset and length of the register set for the device
+- interrupts : Must contain the interrupt id for I2C event and then the
+  interrupt id for I2C error.
+- resets: Must contain the phandle to the reset controller.
+- clocks: Must contain the input clock of the I2C instance.
+- A pinctrl state named "default" must be defined to set pins in mode of
+  operation for I2C transfer
+- #address-cells = <1>;
+- #size-cells = <0>;
+
+Optional properties :
+- clock-frequency : Desired I2C bus clock frequency in Hz. If not specified,
+  the default 100 kHz frequency will be used. As only Normal and Fast modes
+  are supported, possible values are 100000 and 400000.
+
+Example :
+
+	i2c@40005400 {
+		compatible = "st,stm32f4-i2c";
+		#address-cells = <1>;
+		#size-cells = <0>;
+		reg = <0x40005400 0x400>;
+		interrupts = <31>,
+			     <32>;
+		resets = <&rcc 277>;
+		clocks = <&rcc 0 149>;
+		pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
+		pinctrl-names = "default";
+	};