arm64: dts: hi3660: add spi device nodes

Add spi2 and spi3 device nodes for hi3660, and enable them for hikey960.

On HiKey960:
 - SPI2 is wired out through low speed expansion connector.
 - SPI3 is wired out through high speed expansion connector.
Signed-off-by: Wang Xiaoyin <hw.wangxiaoyin@hisilicon.com>
Signed-off-by: Guodong Xu <guodong.xu@linaro.org>
Signed-off-by: Wei Xu <xuwei5@hisilicon.com>

arch/arm64/boot/dts/hisilicon/hi3660-hikey960.dts

@@ -142,3 +142,15 @@ &uart6 {
 	label = "LS-UART1";
 	status = "okay";
 };
+
+&spi2 {
+	/* On Low speed expansion */
+	label = "LS-SPI0";
+	status = "okay";
+};
+
+&spi3 {
+	/* On High speed expansion */
+	label = "HS-SPI1";
+	status = "okay";
+};

arch/arm64/boot/dts/hisilicon/hi3660.dtsi

@@ -713,5 +713,35 @@ gpio28: gpio@fff1d000 {
 			clocks = <&sctrl HI3660_PCLK_AO_GPIO6>;
 			clock-names = "apb_pclk";
 		};
+
+		spi2: spi@ffd68000 {
+			compatible = "arm,pl022", "arm,primecell";
+			reg = <0x0 0xffd68000 0x0 0x1000>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			interrupts = <GIC_SPI 116 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&crg_ctrl HI3660_CLK_GATE_SPI2>;
+			clock-names = "apb_pclk";
+			pinctrl-names = "default";
+			pinctrl-0 = <&spi2_pmx_func>;
+			num-cs = <1>;
+			cs-gpios = <&gpio27 2 0>;
+			status = "disabled";
+		};
+
+		spi3: spi@ff3b3000 {
+			compatible = "arm,pl022", "arm,primecell";
+			reg = <0x0 0xff3b3000 0x0 0x1000>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			interrupts = <GIC_SPI 312 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&crg_ctrl HI3660_CLK_GATE_SPI3>;
+			clock-names = "apb_pclk";
+			pinctrl-names = "default";
+			pinctrl-0 = <&spi3_pmx_func>;
+			num-cs = <1>;
+			cs-gpios = <&gpio18 5 0>;
+			status = "disabled";
+		};
 	};
 };