Commit 39bc30f2 authored by Mark Brown's avatar Mark Brown

Merge remote-tracking branches 'asoc/fix/fsl-mxs-saif' and 'asoc/fix/sunxi' into asoc-linus

......@@ -119,23 +119,33 @@ static int mxs_saif_set_clk(struct mxs_saif *saif,
* Set SAIF clock
*
* The SAIF clock should be either 384*fs or 512*fs.
* If MCLK is used, the SAIF clk ratio need to match mclk ratio.
* For 32x mclk, set saif clk as 512*fs.
* For 48x mclk, set saif clk as 384*fs.
* If MCLK is used, the SAIF clk ratio needs to match mclk ratio.
* For 256x, 128x, 64x, and 32x sub-rates, set saif clk as 512*fs.
* For 192x, 96x, and 48x sub-rates, set saif clk as 384*fs.
*
* If MCLK is not used, we just set saif clk to 512*fs.
*/
clk_prepare_enable(master_saif->clk);
if (master_saif->mclk_in_use) {
if (mclk % 32 == 0) {
switch (mclk / rate) {
case 32:
case 64:
case 128:
case 256:
case 512:
scr &= ~BM_SAIF_CTRL_BITCLK_BASE_RATE;
ret = clk_set_rate(master_saif->clk, 512 * rate);
} else if (mclk % 48 == 0) {
break;
case 48:
case 96:
case 192:
case 384:
scr |= BM_SAIF_CTRL_BITCLK_BASE_RATE;
ret = clk_set_rate(master_saif->clk, 384 * rate);
} else {
/* SAIF MCLK should be either 32x or 48x */
break;
default:
/* SAIF MCLK should be a sub-rate of 512x or 384x */
clk_disable_unprepare(master_saif->clk);
return -EINVAL;
}
......@@ -299,6 +309,16 @@ static int mxs_saif_set_dai_fmt(struct snd_soc_dai *cpu_dai, unsigned int fmt)
return -EBUSY;
}
/* If SAIF1 is configured as slave, the clk gate needs to be cleared
* before the register can be written.
*/
if (saif->id != saif->master_id) {
__raw_writel(BM_SAIF_CTRL_SFTRST,
saif->base + SAIF_CTRL + MXS_CLR_ADDR);
__raw_writel(BM_SAIF_CTRL_CLKGATE,
saif->base + SAIF_CTRL + MXS_CLR_ADDR);
}
scr0 = __raw_readl(saif->base + SAIF_CTRL);
scr0 = scr0 & ~BM_SAIF_CTRL_BITCLK_EDGE & ~BM_SAIF_CTRL_LRCLK_POLARITY \
& ~BM_SAIF_CTRL_JUSTIFY & ~BM_SAIF_CTRL_DELAY;
......
......@@ -694,10 +694,10 @@ static int sun4i_i2s_probe(struct platform_device *pdev)
}
i2s->playback_dma_data.addr = res->start + SUN4I_I2S_FIFO_TX_REG;
i2s->playback_dma_data.maxburst = 4;
i2s->playback_dma_data.maxburst = 8;
i2s->capture_dma_data.addr = res->start + SUN4I_I2S_FIFO_RX_REG;
i2s->capture_dma_data.maxburst = 4;
i2s->capture_dma_data.maxburst = 8;
pm_runtime_enable(&pdev->dev);
if (!pm_runtime_enabled(&pdev->dev)) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment