spi: add support for DLN-2 USB-SPI adapter

This adds support for Diolan DLN2 USB-SPI adapter.

Information about the USB protocol interface can be found in the
Programmer's Reference Manual [1], see section 5.4.6 for the SPI
master module commands and responses.

[1] https://www.diolan.com/downloads/dln-api-manual.pdfSigned-off-by: Laurentiu Palcu <laurentiu.palcu@intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/Kconfig

@@ -185,6 +185,16 @@ config SPI_DAVINCI
 	help
 	  SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
 
+config SPI_DLN2
+       tristate "Diolan DLN-2 USB SPI adapter"
+       depends on MFD_DLN2
+       help
+         If you say yes to this option, support will be included for Diolan
+         DLN2, a USB to SPI interface.
+
+         This driver can also be built as a module.  If so, the module
+         will be called spi-dln2.
+
 config SPI_EFM32
 	tristate "EFM32 SPI controller"
 	depends on OF && ARM && (ARCH_EFM32 || COMPILE_TEST)

drivers/spi/Makefile

@@ -27,6 +27,7 @@ obj-$(CONFIG_SPI_CADENCE)		+= spi-cadence.o
 obj-$(CONFIG_SPI_CLPS711X)		+= spi-clps711x.o
 obj-$(CONFIG_SPI_COLDFIRE_QSPI)		+= spi-coldfire-qspi.o
 obj-$(CONFIG_SPI_DAVINCI)		+= spi-davinci.o
+obj-$(CONFIG_SPI_DLN2)			+= spi-dln2.o
 obj-$(CONFIG_SPI_DESIGNWARE)		+= spi-dw.o
 obj-$(CONFIG_SPI_DW_MMIO)		+= spi-dw-mmio.o
 obj-$(CONFIG_SPI_DW_PCI)		+= spi-dw-midpci.o