bnx2: Enable auto-mdix when autoneg is disabled.

Auto-mdix currently only works if autoneg is enabled.  This patch enables
auto-mdix all the time by setting a bit in a PHY register.  Define
meaningful constants for this PHY registers.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnx2.c

@@ -2343,9 +2343,15 @@ bnx2_init_copper_phy(struct bnx2 *bp, int reset_phy)
 	}
 
 	/* ethernet@wirespeed */
-	bnx2_write_phy(bp, 0x18, 0x7007);
-	bnx2_read_phy(bp, 0x18, &val);
-	bnx2_write_phy(bp, 0x18, val | (1 << 15) | (1 << 4));
+	bnx2_write_phy(bp, MII_BNX2_AUX_CTL, AUX_CTL_MISC_CTL);
+	bnx2_read_phy(bp, MII_BNX2_AUX_CTL, &val);
+	val |=  AUX_CTL_MISC_CTL_WR | AUX_CTL_MISC_CTL_WIRESPEED;
+
+	/* auto-mdix */
+	if (BNX2_CHIP(bp) == BNX2_CHIP_5709)
+		val |=  AUX_CTL_MISC_CTL_AUTOMDIX;
+
+	bnx2_write_phy(bp, MII_BNX2_AUX_CTL, val);
 	return 0;
 }
 

drivers/net/ethernet/broadcom/bnx2.h

@@ -6471,6 +6471,12 @@ struct l2_fhdr {
 
 #define BCM5708S_TX_ACTL3			0x17
 
+#define MII_BNX2_AUX_CTL			0x18
+#define AUX_CTL_MISC_CTL			 0x7007
+#define AUX_CTL_MISC_CTL_WIRESPEED		  (1 << 4)
+#define AUX_CTL_MISC_CTL_AUTOMDIX		  (1 << 9)
+#define AUX_CTL_MISC_CTL_WR			  (1 << 15)
+
 #define MII_BNX2_DSP_RW_PORT			0x15
 #define MII_BNX2_DSP_ADDRESS			0x17
 #define MII_BNX2_DSP_EXPAND_REG			 0x0f00