ath9k_hw: Do not enable IQ-CAL for half/quarter rates

IQ calibration doesn't complete and times out for half/quarter
rates, so skip it correctly.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/ath/ath9k/ar9003_calib.c

@@ -1013,7 +1013,8 @@ static bool ar9003_hw_init_cal(struct ath_hw *ah,
 		}
 	}
 
-	if (!(ah->enabled_cals & TX_IQ_CAL))
+	if ((IS_CHAN_HALF_RATE(chan) || IS_CHAN_QUARTER_RATE(chan)) ||
+	    !(ah->enabled_cals & TX_IQ_CAL))
 		goto skip_tx_iqcal;
 
 	/* Do Tx IQ Calibration */
@@ -1040,12 +1041,10 @@ static bool ar9003_hw_init_cal(struct ath_hw *ah,
 	if (ath9k_hw_mci_is_enabled(ah) && IS_CHAN_2GHZ(chan) && run_agc_cal)
 		ar9003_mci_init_cal_req(ah, &is_reusable);
 
-	if (!(IS_CHAN_HALF_RATE(chan) || IS_CHAN_QUARTER_RATE(chan))) {
-		txiqcal_done = ar9003_hw_tx_iq_cal_run(ah);
-		REG_WRITE(ah, AR_PHY_ACTIVE, AR_PHY_ACTIVE_DIS);
-		udelay(5);
-		REG_WRITE(ah, AR_PHY_ACTIVE, AR_PHY_ACTIVE_EN);
-	}
+	txiqcal_done = ar9003_hw_tx_iq_cal_run(ah);
+	REG_WRITE(ah, AR_PHY_ACTIVE, AR_PHY_ACTIVE_DIS);
+	udelay(5);
+	REG_WRITE(ah, AR_PHY_ACTIVE, AR_PHY_ACTIVE_EN);
 
 skip_tx_iqcal:
 	if (run_agc_cal || !(ah->ah_flags & AH_FASTCC)) {