Commit 4a37c106 authored by Dean Gaudet's avatar Dean Gaudet Committed by Linus Torvalds

[PATCH] better ali1563 integrated ethernet support

it turns out the tulip driver is a much better driver for the integrated
ali1563 ethernet than the dmfe driver... the dmfe driver gets tx timeouts
every ~15s and can't receive over 5MB/s.  but with the small tulip patch
below i'm seeing 11MB/s+ in both directions without problems.
parent 213bead0
......@@ -223,6 +223,7 @@ static struct pci_device_id tulip_pci_tbl[] __devinitdata = {
{ 0x1626, 0x8410, PCI_ANY_ID, PCI_ANY_ID, 0, 0, COMET },
{ 0x1737, 0xAB09, PCI_ANY_ID, PCI_ANY_ID, 0, 0, COMET },
{ 0x17B3, 0xAB08, PCI_ANY_ID, PCI_ANY_ID, 0, 0, COMET },
{ 0x10b9, 0x5261, PCI_ANY_ID, PCI_ANY_ID, 0, 0, DM910X }, /* ALi 1563 integrated ethernet */
{ } /* terminate list */
};
MODULE_DEVICE_TABLE(pci, tulip_pci_tbl);
......@@ -1325,12 +1326,14 @@ static int __devinit tulip_init_one (struct pci_dev *pdev,
csr0 &= ~0xfff10000; /* zero reserved bits 31:20, 16 */
/* DM9102A has troubles with MRM & clear reserved bits 24:22, 20, 16, 7:1 */
if (pdev->vendor == 0x1282 && pdev->device == 0x9102)
if ((pdev->vendor == 0x1282 && pdev->device == 0x9102)
|| (pdev->vendor == 0x10b9 && pdev->device == 0x5261))
csr0 &= ~0x01f100ff;
#if defined(__sparc__)
/* DM9102A needs 32-dword alignment/burst length on sparc - chip bug? */
if (pdev->vendor == 0x1282 && pdev->device == 0x9102)
if ((pdev->vendor == 0x1282 && pdev->device == 0x9102)
|| (pdev->vendor == 0x10b9 && pdev->device == 0x5261))
csr0 = (csr0 & ~0xff00) | 0xe000;
#endif
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment