ath10k: fix the wrong RX rate idx report at 11G mode

The RX rate idx is not correct for 11G mode OFDM packet.
Because the bitrate table start with CCK index instead of OFDM.
Signed-off-by: Yanbo Li <yanbol@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/htt_rx.c

@@ -674,7 +674,7 @@ static void ath10k_htt_rx_h_rates(struct ath10k *ar,
 		rate &= ~RX_PPDU_START_RATE_FLAG;
 
 		sband = &ar->mac.sbands[status->band];
-		status->rate_idx = ath10k_mac_hw_rate_to_idx(sband, rate);
+		status->rate_idx = ath10k_mac_hw_rate_to_idx(sband, rate, cck);
 		break;
 	case HTT_RX_HT:
 	case HTT_RX_HT_WITH_TXBF:

drivers/net/wireless/ath/ath10k/mac.c

@@ -90,7 +90,7 @@ static u8 ath10k_mac_bitrate_to_rate(int bitrate)
 }
 
 u8 ath10k_mac_hw_rate_to_idx(const struct ieee80211_supported_band *sband,
-			     u8 hw_rate)
+			     u8 hw_rate, bool cck)
 {
 	const struct ieee80211_rate *rate;
 	int i;
@@ -98,6 +98,9 @@ u8 ath10k_mac_hw_rate_to_idx(const struct ieee80211_supported_band *sband,
 	for (i = 0; i < sband->n_bitrates; i++) {
 		rate = &sband->bitrates[i];
 
+		if (ath10k_mac_bitrate_is_cck(rate->bitrate) != cck)
+			continue;
+
 		if (rate->hw_value == hw_rate)
 			return i;
 		else if (rate->flags & IEEE80211_RATE_SHORT_PREAMBLE &&

drivers/net/wireless/ath/ath10k/mac.h

@@ -66,7 +66,7 @@ void ath10k_mac_handle_tx_pause_vdev(struct ath10k *ar, u32 vdev_id,
 				     enum wmi_tlv_tx_pause_action action);
 
 u8 ath10k_mac_hw_rate_to_idx(const struct ieee80211_supported_band *sband,
-			     u8 hw_rate);
+			     u8 hw_rate, bool cck);
 u8 ath10k_mac_bitrate_to_idx(const struct ieee80211_supported_band *sband,
 			     u32 bitrate);