dmaengine: hsu: correct use of channel status register

There is a typo in documentation regarding to descriptor empty bit (DESCE)
which is set to 1 when descriptor is empty. Thus, status register at the end of
a transfer usually returns all DESCE bits set and thus it will never be zero.

Moreover, there are 2 bits (CDESC) that encode current descriptor, on which
interrupt has been asserted. In case when we have few descriptors programmed we
might have non-zero value.

Remove DESCE and CDESC bits from DMA channel status register (HSU_CH_SR) when
reading it.

Fixes: 2b49e0c5 ("dmaengine: append hsu DMA driver")
Cc: stable@vger.kernel.org
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>

drivers/dma/hsu/hsu.c

@@ -135,7 +135,7 @@ static u32 hsu_dma_chan_get_sr(struct hsu_dma_chan *hsuc)
 	sr = hsu_chan_readl(hsuc, HSU_CH_SR);
 	spin_unlock_irqrestore(&hsuc->vchan.lock, flags);
 
-	return sr;
+	return sr & ~(HSU_CH_SR_DESCE_ANY | HSU_CH_SR_CDESC_ANY);
 }
 
 irqreturn_t hsu_dma_irq(struct hsu_dma_chip *chip, unsigned short nr)

drivers/dma/hsu/hsu.h

@@ -41,6 +41,9 @@
 #define HSU_CH_SR_DESCTO(x)	BIT(8 + (x))
 #define HSU_CH_SR_DESCTO_ANY	(BIT(11) | BIT(10) | BIT(9) | BIT(8))
 #define HSU_CH_SR_CHE		BIT(15)
+#define HSU_CH_SR_DESCE(x)	BIT(16 + (x))
+#define HSU_CH_SR_DESCE_ANY	(BIT(19) | BIT(18) | BIT(17) | BIT(16))
+#define HSU_CH_SR_CDESC_ANY	(BIT(31) | BIT(30))
 
 /* Bits in HSU_CH_CR */
 #define HSU_CH_CR_CHA		BIT(0)