Commit 531f254e authored by Bjorn Helgaas's avatar Bjorn Helgaas Committed by Jesse Barnes

PCIE: aer: use dev_printk when possible

Convert printks to use dev_printk().
Signed-off-by: default avatarBjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: default avatarJesse Barnes <jbarnes@virtuousgeek.org>
parent 80ccba11
......@@ -220,8 +220,7 @@ static int __devinit aer_probe (struct pcie_device *dev,
/* Alloc rpc data structure */
if (!(rpc = aer_alloc_rpc(dev))) {
printk(KERN_DEBUG "%s: Alloc rpc fails on PCIE device[%s]\n",
__func__, device->bus_id);
dev_printk(KERN_DEBUG, device, "alloc rpc failed\n");
aer_remove(dev);
return -ENOMEM;
}
......@@ -229,8 +228,7 @@ static int __devinit aer_probe (struct pcie_device *dev,
/* Request IRQ ISR */
if ((status = request_irq(dev->irq, aer_irq, IRQF_SHARED, "aerdrv",
dev))) {
printk(KERN_DEBUG "%s: Request ISR fails on PCIE device[%s]\n",
__func__, device->bus_id);
dev_printk(KERN_DEBUG, device, "request IRQ failed\n");
aer_remove(dev);
return status;
}
......@@ -274,7 +272,7 @@ static pci_ers_result_t aer_root_reset(struct pci_dev *dev)
* to issue Configuration Requests to those devices.
*/
msleep(200);
printk(KERN_DEBUG "Complete link reset at Root[%s]\n", dev->dev.bus_id);
dev_printk(KERN_DEBUG, &dev->dev, "Root Port link has been reset\n");
/* Enable Root Port's interrupt in response to error messages */
pci_read_config_dword(dev, pos + PCI_ERR_ROOT_STATUS, &status);
......
......@@ -50,10 +50,10 @@ int aer_osc_setup(struct pcie_device *pciedev)
}
if (ACPI_FAILURE(status)) {
printk(KERN_DEBUG "AER service couldn't init device %s - %s\n",
pciedev->device.bus_id,
(status == AE_SUPPORT || status == AE_NOT_FOUND) ?
"no _OSC support" : "Run ACPI _OSC fails");
dev_printk(KERN_DEBUG, &pciedev->device, "AER service couldn't "
"init device: %s\n",
(status == AE_SUPPORT || status == AE_NOT_FOUND) ?
"no _OSC support" : "_OSC failed");
return -1;
}
......
......@@ -221,9 +221,9 @@ static void report_error_detected(struct pci_dev *dev, void *data)
* of a driver for this device is unaware of
* its hw state.
*/
printk(KERN_DEBUG "Device ID[%s] has %s\n",
dev->dev.bus_id, (dev->driver) ?
"no AER-aware driver" : "no driver");
dev_printk(KERN_DEBUG, &dev->dev, "device has %s\n",
dev->driver ?
"no AER-aware driver" : "no driver");
}
return;
}
......@@ -304,7 +304,7 @@ static pci_ers_result_t broadcast_error_message(struct pci_dev *dev,
{
struct aer_broadcast_data result_data;
printk(KERN_DEBUG "Broadcast %s message\n", error_mesg);
dev_printk(KERN_DEBUG, &dev->dev, "broadcast %s message\n", error_mesg);
result_data.state = state;
if (cb == report_error_detected)
result_data.result = PCI_ERS_RESULT_CAN_RECOVER;
......@@ -404,18 +404,16 @@ static pci_ers_result_t reset_link(struct pcie_device *aerdev,
data.aer_driver =
to_service_driver(aerdev->device.driver);
} else {
printk(KERN_DEBUG "No link-reset support to Device ID"
"[%s]\n",
dev->dev.bus_id);
dev_printk(KERN_DEBUG, &dev->dev, "no link-reset "
"support\n");
return PCI_ERS_RESULT_DISCONNECT;
}
}
status = data.aer_driver->reset_link(udev);
if (status != PCI_ERS_RESULT_RECOVERED) {
printk(KERN_DEBUG "Link reset at upstream Device ID"
"[%s] failed\n",
udev->dev.bus_id);
dev_printk(KERN_DEBUG, &dev->dev, "link reset at upstream "
"device %s failed\n", pci_name(udev));
return PCI_ERS_RESULT_DISCONNECT;
}
......@@ -511,10 +509,12 @@ static void handle_error_source(struct pcie_device * aerdev,
} else {
status = do_recovery(aerdev, dev, info.severity);
if (status == PCI_ERS_RESULT_RECOVERED) {
printk(KERN_DEBUG "AER driver successfully recovered\n");
dev_printk(KERN_DEBUG, &dev->dev, "AER driver "
"successfully recovered\n");
} else {
/* TODO: Should kernel panic here? */
printk(KERN_DEBUG "AER driver didn't recover\n");
dev_printk(KERN_DEBUG, &dev->dev, "AER driver didn't "
"recover\n");
}
}
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment