Commit 548d3506 authored by Derek Robson's avatar Derek Robson Committed by Greg Kroah-Hartman

Staging: rtl8192u: ieee80211: ieee80211.h - style fix

Fixed style of block comments
Found using checkpatch
Signed-off-by: default avatarDerek Robson <robsonde@gmail.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent b8edc163
......@@ -329,12 +329,13 @@ typedef struct ieee_param {
// linux under 2.6.9 release may not support it, so modify it for common use
#define IEEE80211_DATA_LEN 2304
/* Maximum size for the MA-UNITDATA primitive, 802.11 standard section
6.2.1.1.2.
The figure in section 7.1.2 suggests a body size of up to 2312
bytes is allowed, which is a bit confusing, I suspect this
represents the 2304 bytes of real data, plus a possible 8 bytes of
WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro) */
* 6.2.1.1.2.
*
* The figure in section 7.1.2 suggests a body size of up to 2312
* bytes is allowed, which is a bit confusing, I suspect this
* represents the 2304 bytes of real data, plus a possible 8 bytes of
* WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro)
*/
#define IEEE80211_1ADDR_LEN 10
#define IEEE80211_2ADDR_LEN 16
#define IEEE80211_3ADDR_LEN 24
......@@ -685,7 +686,8 @@ struct ieee_ibss_seq {
/* NOTE: This data is for statistical purposes; not all hardware provides this
* information for frames received. Not setting these will not cause
* any adverse affects. */
* any adverse affects.
*/
struct ieee80211_rx_stats {
u32 mac_time[2];
s8 rssi;
......@@ -754,7 +756,8 @@ struct ieee80211_rx_stats {
/* IEEE 802.11 requires that STA supports concurrent reception of at least
* three fragmented frames. This define can be increased to support more
* concurrent frames, but it should be noted that each entry can consume about
* 2 kB of RAM and increasing cache size will slow down frame reassembly. */
* 2 kB of RAM and increasing cache size will slow down frame reassembly.
*/
#define IEEE80211_FRAG_CACHE_LEN 4
struct ieee80211_frag_entry {
......@@ -836,15 +839,15 @@ struct ieee80211_security {
/*
802.11 data frame from AP
,-------------------------------------------------------------------.
Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 |
|------|------|---------|---------|---------|------|---------|------|
Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs |
| | tion | (BSSID) | | | ence | data | |
`-------------------------------------------------------------------'
Total: 28-2340 bytes
*/
* 802.11 data frame from AP
* ,-------------------------------------------------------------------.
* Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 |
* |------|------|---------|---------|---------|------|---------|------|
* Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs |
* | | tion | (BSSID) | | | ence | data | |
* `-------------------------------------------------------------------'
* Total: 28-2340 bytes
*/
/* Management Frame Information Element Types */
enum ieee80211_mfie {
......@@ -882,7 +885,8 @@ enum ieee80211_mfie {
/* Minimal header; can be used for passing 802.11 frames with sufficient
* information to determine what type of underlying data type is actually
* stored in the data. */
* stored in the data.
*/
struct rtl_80211_hdr {
__le16 frame_ctl;
__le16 duration_id;
......@@ -980,7 +984,8 @@ struct ieee80211_probe_response {
__le16 beacon_interval;
__le16 capability;
/* SSID, supported rates, FH params, DS params,
* CF params, IBSS params, TIM (if beacon), RSN */
* CF params, IBSS params, TIM (if beacon), RSN
*/
struct ieee80211_info_element info_element[0];
} __packed;
......@@ -1055,7 +1060,8 @@ typedef union _frameqos {
/* MAX_RATES_LENGTH needs to be 12. The spec says 8, and many APs
* only use 8, and then use extended rates for the remaining supported
* rates. Other APs, however, stick all of their supported rates on the
* main rates information element... */
* main rates information element...
*/
#define MAX_RATES_LENGTH ((u8)12)
#define MAX_RATES_EX_LENGTH ((u8)16)
#define MAX_NETWORK_COUNT 128
......@@ -1677,14 +1683,16 @@ struct ieee80211_device {
spinlock_t wpax_suitlist_lock;
int tx_headroom; /* Set to size of any additional room needed at front
* of allocated Tx SKBs */
* of allocated Tx SKBs
*/
u32 config;
/* WEP and other encryption related settings at the device level */
int open_wep; /* Set to 1 to allow unencrypted frames */
int auth_mode;
int reset_on_keychange; /* Set to 1 if the HW needs to be reset on
* WEP key changes */
* WEP key changes
*/
/* If the host performs {en,de}cryption, then set to 1 */
int host_encrypt;
......@@ -1719,7 +1727,8 @@ struct ieee80211_device {
int crypt_quiesced;
int bcrx_sta_key; /* use individual keys to override default keys even
* with RX of broad/multicast frames */
* with RX of broad/multicast frames
*/
/* Fragmentation structures */
// each streaming contain a entry
......@@ -2004,7 +2013,8 @@ struct ieee80211_device {
void (*InitialGainHandler)(struct net_device *dev, u8 Operation);
/* This must be the last item so that it points to the data
* allocated beyond this structure by alloc_ieee80211 */
* allocated beyond this structure by alloc_ieee80211
*/
u8 priv[0];
};
......@@ -2033,7 +2043,8 @@ struct ieee80211_device {
/* The ieee802.11 stack will manages the netif queue
* wake/stop for the driver, taking care of 802.11
* fragmentation. See softmac.c for details. */
* fragmentation. See softmac.c for details.
*/
#define IEEE_SOFTMAC_TX_QUEUE (1<<7)
/* Uses only the softmac_data_hard_start_xmit
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment