Commit 5616b0a4 authored by Martin K. Petersen's avatar Martin K. Petersen Committed by James Bottomley

[SCSI] use the scsi data buffer length to extract transfer size

Commit 8846bab1 introduced a helper that can be used to query the
wire transfer size for a SCSI command taking protection information into
account.

However, some commands do not have a 1:1 mapping between the block range
they work on and the payload size (discard, write same). After the
scatterlist has been set up these requests use __data_len to store the
number of bytes to report completion on. This means that callers of
scsi_transfer_length() would get the wrong byte count for these types of
requests.

To overcome this we make scsi_transfer_length() use the scatterlist
length in the scsi_data_buffer as basis for the wire transfer
calculation instead of __data_len.
Reported-by: default avatarChristoph Hellwig <hch@infradead.org>
Debugged-by: default avatarMike Christie <michaelc@cs.wisc.edu>
Signed-off-by: default avatarMartin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: default avatarChristoph Hellwig <hch@lst.de>
Reviewed-by: default avatarSagi Grimberg <sagig@mellanox.com>
Fixes: d77e6535
Cc: stable@vger.kernel.org
Signed-off-by: default avatarJames Bottomley <JBottomley@Parallels.com>
parent a33c070b
...@@ -318,7 +318,7 @@ static inline void set_driver_byte(struct scsi_cmnd *cmd, char status) ...@@ -318,7 +318,7 @@ static inline void set_driver_byte(struct scsi_cmnd *cmd, char status)
static inline unsigned scsi_transfer_length(struct scsi_cmnd *scmd) static inline unsigned scsi_transfer_length(struct scsi_cmnd *scmd)
{ {
unsigned int xfer_len = blk_rq_bytes(scmd->request); unsigned int xfer_len = scsi_out(scmd)->length;
unsigned int prot_op = scsi_get_prot_op(scmd); unsigned int prot_op = scsi_get_prot_op(scmd);
unsigned int sector_size = scmd->device->sector_size; unsigned int sector_size = scmd->device->sector_size;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment