serial/imx: read cts state only after acking cts change irq

If cts changes between reading the level at the cts input (USR1_RTSS)
and acking the irq (USR1_RTSD) the last edge doesn't generate an irq and
uart_handle_cts_change is called with a outdated value for cts.

The race was introduced by commit

	ceca629e ([ARM] 2971/1: i.MX uart handle rts irq)
Reported-by: Arwed Springer <Arwed.Springer@de.trumpf.com>
Tested-by: Arwed Springer <Arwed.Springer@de.trumpf.com>
Cc: stable@kernel.org # 2.6.14+
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

drivers/tty/serial/imx.c

@@ -382,12 +382,13 @@ static void imx_start_tx(struct uart_port *port)
 static irqreturn_t imx_rtsint(int irq, void *dev_id)
 {
 	struct imx_port *sport = dev_id;
-	unsigned int val = readl(sport->port.membase + USR1) & USR1_RTSS;
+	unsigned int val;
 	unsigned long flags;
 
 	spin_lock_irqsave(&sport->port.lock, flags);
 
 	writel(USR1_RTSD, sport->port.membase + USR1);
+	val = readl(sport->port.membase + USR1) & USR1_RTSS;
 	uart_handle_cts_change(&sport->port, !!val);
 	wake_up_interruptible(&sport->port.state->port.delta_msr_wait);