md: cancel check/repair requests when recovery is needed

If a 'repair' is requested when an array is in a position to 'recover' raid1
will perform the repair while md believes a recovery is happening.  Address
this at both ends, i.e. cancel check/repair requests upon detecting a
recover condition and do not call ->spare_active after completing a
check/repair.
Signed-off-by: Dan Williams <dan.j.williams@intel.com>

drivers/md/md.c

@@ -6138,7 +6138,8 @@ void md_check_recovery(mddev_t *mddev)
 			/* resync has finished, collect result */
 			md_unregister_thread(mddev->sync_thread);
 			mddev->sync_thread = NULL;
-			if (!test_bit(MD_RECOVERY_INTR, &mddev->recovery)) {
+			if (!test_bit(MD_RECOVERY_INTR, &mddev->recovery) &&
+			    !test_bit(MD_RECOVERY_REQUESTED, &mddev->recovery)) {
 				/* success...*/
 				/* activate any spares */
 				if (mddev->pers->spare_active(mddev))
@@ -6190,6 +6191,7 @@ void md_check_recovery(mddev_t *mddev)
 		} else if ((spares = remove_and_add_spares(mddev))) {
 			clear_bit(MD_RECOVERY_SYNC, &mddev->recovery);
 			clear_bit(MD_RECOVERY_CHECK, &mddev->recovery);
+			clear_bit(MD_RECOVERY_REQUESTED, &mddev->recovery);
 			set_bit(MD_RECOVERY_RECOVER, &mddev->recovery);
 		} else if (mddev->recovery_cp < MaxSector) {
 			set_bit(MD_RECOVERY_SYNC, &mddev->recovery);