Add irq_flags to struct pata_platform_info

On some embedded platforms, such as blackfin, the gpio interrupt for
IDE interface is designed to be triggered with high voltage. The gpio
port should be configured properly by set_irq_type() when register
the irq. This patch enable the generic pata platform driver to
accept platform irq flags data.
Signed-off-by: Sonic Zhang <sonic.adi@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

drivers/ata/pata_platform.c

@@ -139,6 +139,7 @@ static int __devinit pata_platform_probe(struct platform_device *pdev)
 	struct resource *io_res, *ctl_res;
 	struct ata_host *host;
 	struct ata_port *ap;
+	struct pata_platform_info *pp_info;
 	unsigned int mmio;
 
 	/*
@@ -208,11 +209,12 @@ static int __devinit pata_platform_probe(struct platform_device *pdev)
 
 	ap->ioaddr.altstatus_addr = ap->ioaddr.ctl_addr;
 
-	pata_platform_setup_port(&ap->ioaddr, pdev->dev.platform_data);
+	pp_info = (struct pata_platform_info *)(pdev->dev.platform_data);
+	pata_platform_setup_port(&ap->ioaddr, pp_info);
 
 	/* activate */
 	return ata_host_activate(host, platform_get_irq(pdev, 0), ata_interrupt,
-				 0, &pata_platform_sht);
+				 pp_info->irq_flags, &pata_platform_sht);
 }
 
 /**

include/linux/pata_platform.h

@@ -8,6 +8,11 @@ struct pata_platform_info {
 	 * spacing used by ata_std_ports().
 	 */
 	unsigned int ioport_shift;
+	/* 
+	 * Indicate platform specific irq types and initial
+	 * IRQ flags when call request_irq()
+	 */
+	unsigned int irq_flags;
 };
 
 #endif /* __LINUX_PATA_PLATFORM_H */