Commit 5fec5b5a authored by Bryan Wu's avatar Bryan Wu Committed by Linus Torvalds

spi: spi_bfin cleanups, error handling

Cleanup and error handling

 - add error handling in SPI bus driver with selecting clients
 - use proper defines to access Blackfin MMRs
 - remove useless SSYNCs
 - cleaner use of portmux calls
Signed-off-by: default avatarMichael Hennerich <michael.hennerich@analog.com>
Signed-off-by: default avatarBryan Wu <bryan.wu@analog.com>
Signed-off-by: default avatarDavid Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: default avatarAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
parent cc2f81a6
......@@ -59,10 +59,9 @@ MODULE_LICENSE("GPL");
#define DEFINE_SPI_REG(reg, off) \
static inline u16 read_##reg(void) \
{ return *(volatile unsigned short*)(SPI0_REGBASE + off); } \
{ return bfin_read16(SPI0_REGBASE + off); } \
static inline void write_##reg(u16 v) \
{*(volatile unsigned short*)(SPI0_REGBASE + off) = v;\
SSYNC();}
{bfin_write16(SPI0_REGBASE + off, v); }
DEFINE_SPI_REG(CTRL, 0x00)
DEFINE_SPI_REG(FLAG, 0x04)
......@@ -145,7 +144,6 @@ static void bfin_spi_enable(struct driver_data *drv_data)
cr = read_CTRL();
write_CTRL(cr | BIT_CTL_ENABLE);
SSYNC();
}
static void bfin_spi_disable(struct driver_data *drv_data)
......@@ -154,7 +152,6 @@ static void bfin_spi_disable(struct driver_data *drv_data)
cr = read_CTRL();
write_CTRL(cr & (~BIT_CTL_ENABLE));
SSYNC();
}
/* Caculate the SPI_BAUD register value based on input HZ */
......@@ -182,52 +179,44 @@ static int flush(struct driver_data *drv_data)
return limit;
}
#define MAX_SPI0_SSEL 7
/* stop controller and re-config current chip*/
static void restore_state(struct driver_data *drv_data)
static int restore_state(struct driver_data *drv_data)
{
struct chip_data *chip = drv_data->cur_chip;
int ret = 0;
u16 ssel[MAX_SPI0_SSEL] = {P_SPI0_SSEL1, P_SPI0_SSEL2, P_SPI0_SSEL3,
P_SPI0_SSEL4, P_SPI0_SSEL5,
P_SPI0_SSEL6, P_SPI0_SSEL7,};
/* Clear status and disable clock */
write_STAT(BIT_STAT_CLR);
bfin_spi_disable(drv_data);
dev_dbg(&drv_data->pdev->dev, "restoring spi ctl state\n");
/* Load the registers */
write_CTRL(chip->ctl_reg);
write_BAUD(chip->baud);
write_FLAG(chip->flag);
if (!chip->chip_select_requested) {
int i = chip->chip_select_num;
dev_dbg(&drv_data->pdev->dev,
"chip select number is %d\n", chip->chip_select_num);
switch (chip->chip_select_num) {
case 1:
peripheral_request(P_SPI0_SSEL1, DRV_NAME);
break;
case 2:
peripheral_request(P_SPI0_SSEL2, DRV_NAME);
break;
case 3:
peripheral_request(P_SPI0_SSEL3, DRV_NAME);
break;
case 4:
peripheral_request(P_SPI0_SSEL4, DRV_NAME);
break;
case 5:
peripheral_request(P_SPI0_SSEL5, DRV_NAME);
break;
case 6:
peripheral_request(P_SPI0_SSEL6, DRV_NAME);
break;
case 7:
peripheral_request(P_SPI0_SSEL7, DRV_NAME);
break;
}
dev_dbg(&drv_data->pdev->dev, "chip select number is %d\n", i);
if ((i > 0) && (i <= MAX_SPI0_SSEL))
ret = peripheral_request(ssel[i-1], DRV_NAME);
chip->chip_select_requested = 1;
}
/* Load the registers */
write_CTRL(chip->ctl_reg);
write_BAUD(chip->baud);
write_FLAG(chip->flag);
if (ret)
dev_dbg(&drv_data->pdev->dev,
": request chip select number %d failed\n",
chip->chip_select_num);
return ret;
}
/* used to kick off transfer in rx mode */
......@@ -285,7 +274,6 @@ static void u8_cs_chg_writer(struct driver_data *drv_data)
while (drv_data->tx < drv_data->tx_end) {
write_FLAG(chip->flag);
SSYNC();
write_TDBR(*(u8 *) (drv_data->tx));
while (read_STAT() & BIT_STAT_TXS)
......@@ -293,13 +281,13 @@ static void u8_cs_chg_writer(struct driver_data *drv_data)
while (!(read_STAT() & BIT_STAT_SPIF))
continue;
write_FLAG(0xFF00 | chip->flag);
SSYNC();
if (chip->cs_chg_udelay)
udelay(chip->cs_chg_udelay);
++drv_data->tx;
}
write_FLAG(0xFF00);
SSYNC();
}
static void u8_reader(struct driver_data *drv_data)
......@@ -331,7 +319,6 @@ static void u8_cs_chg_reader(struct driver_data *drv_data)
while (drv_data->rx < drv_data->rx_end) {
write_FLAG(chip->flag);
SSYNC();
read_RDBR(); /* kick off */
while (!(read_STAT() & BIT_STAT_RXS))
......@@ -340,13 +327,13 @@ static void u8_cs_chg_reader(struct driver_data *drv_data)
continue;
*(u8 *) (drv_data->rx) = read_SHAW();
write_FLAG(0xFF00 | chip->flag);
SSYNC();
if (chip->cs_chg_udelay)
udelay(chip->cs_chg_udelay);
++drv_data->rx;
}
write_FLAG(0xFF00);
SSYNC();
}
static void u8_duplex(struct driver_data *drv_data)
......@@ -370,7 +357,7 @@ static void u8_cs_chg_duplex(struct driver_data *drv_data)
while (drv_data->rx < drv_data->rx_end) {
write_FLAG(chip->flag);
SSYNC();
write_TDBR(*(u8 *) (drv_data->tx));
while (!(read_STAT() & BIT_STAT_SPIF))
......@@ -379,14 +366,14 @@ static void u8_cs_chg_duplex(struct driver_data *drv_data)
continue;
*(u8 *) (drv_data->rx) = read_RDBR();
write_FLAG(0xFF00 | chip->flag);
SSYNC();
if (chip->cs_chg_udelay)
udelay(chip->cs_chg_udelay);
++drv_data->rx;
++drv_data->tx;
}
write_FLAG(0xFF00);
SSYNC();
}
static void u16_writer(struct driver_data *drv_data)
......@@ -412,7 +399,6 @@ static void u16_cs_chg_writer(struct driver_data *drv_data)
while (drv_data->tx < drv_data->tx_end) {
write_FLAG(chip->flag);
SSYNC();
write_TDBR(*(u16 *) (drv_data->tx));
while ((read_STAT() & BIT_STAT_TXS))
......@@ -420,13 +406,12 @@ static void u16_cs_chg_writer(struct driver_data *drv_data)
while (!(read_STAT() & BIT_STAT_SPIF))
continue;
write_FLAG(0xFF00 | chip->flag);
SSYNC();
if (chip->cs_chg_udelay)
udelay(chip->cs_chg_udelay);
drv_data->tx += 2;
}
write_FLAG(0xFF00);
SSYNC();
}
static void u16_reader(struct driver_data *drv_data)
......@@ -454,7 +439,6 @@ static void u16_cs_chg_reader(struct driver_data *drv_data)
while (drv_data->rx < drv_data->rx_end) {
write_FLAG(chip->flag);
SSYNC();
read_RDBR(); /* kick off */
while (!(read_STAT() & BIT_STAT_RXS))
......@@ -463,13 +447,12 @@ static void u16_cs_chg_reader(struct driver_data *drv_data)
continue;
*(u16 *) (drv_data->rx) = read_SHAW();
write_FLAG(0xFF00 | chip->flag);
SSYNC();
if (chip->cs_chg_udelay)
udelay(chip->cs_chg_udelay);
drv_data->rx += 2;
}
write_FLAG(0xFF00);
SSYNC();
}
static void u16_duplex(struct driver_data *drv_data)
......@@ -493,7 +476,6 @@ static void u16_cs_chg_duplex(struct driver_data *drv_data)
while (drv_data->tx < drv_data->tx_end) {
write_FLAG(chip->flag);
SSYNC();
write_TDBR(*(u16 *) (drv_data->tx));
while (!(read_STAT() & BIT_STAT_SPIF))
......@@ -502,14 +484,13 @@ static void u16_cs_chg_duplex(struct driver_data *drv_data)
continue;
*(u16 *) (drv_data->rx) = read_RDBR();
write_FLAG(0xFF00 | chip->flag);
SSYNC();
if (chip->cs_chg_udelay)
udelay(chip->cs_chg_udelay);
drv_data->rx += 2;
drv_data->tx += 2;
}
write_FLAG(0xFF00);
SSYNC();
}
/* test if ther is more transfer to be done */
......@@ -811,7 +792,6 @@ static void pump_transfers(unsigned long data)
"IO duplex: cr is 0x%x\n", cr);
write_CTRL(cr);
SSYNC();
drv_data->duplex(drv_data);
......@@ -826,7 +806,6 @@ static void pump_transfers(unsigned long data)
"IO write: cr is 0x%x\n", cr);
write_CTRL(cr);
SSYNC();
drv_data->write(drv_data);
......@@ -841,7 +820,6 @@ static void pump_transfers(unsigned long data)
"IO read: cr is 0x%x\n", cr);
write_CTRL(cr);
SSYNC();
drv_data->read(drv_data);
if (drv_data->rx != drv_data->rx_end)
......@@ -892,6 +870,14 @@ static void pump_messages(struct work_struct *work)
/* Extract head of queue */
drv_data->cur_msg = list_entry(drv_data->queue.next,
struct spi_message, queue);
/* Setup the SSP using the per chip configuration */
drv_data->cur_chip = spi_get_ctldata(drv_data->cur_msg->spi);
if (restore_state(drv_data)) {
spin_unlock_irqrestore(&drv_data->lock, flags);
return;
};
list_del_init(&drv_data->cur_msg->queue);
/* Initial message state */
......@@ -899,13 +885,10 @@ static void pump_messages(struct work_struct *work)
drv_data->cur_transfer = list_entry(drv_data->cur_msg->transfers.next,
struct spi_transfer, transfer_list);
/* Setup the SSP using the per chip configuration */
drv_data->cur_chip = spi_get_ctldata(drv_data->cur_msg->spi);
restore_state(drv_data);
dev_dbg(&drv_data->pdev->dev,
"got a message to pump, state is set to: baud %d, flag 0x%x, ctl 0x%x\n",
drv_data->cur_chip->baud, drv_data->cur_chip->flag,
drv_data->cur_chip->ctl_reg);
dev_dbg(&drv_data->pdev->dev, "got a message to pump, "
"state is set to: baud %d, flag 0x%x, ctl 0x%x\n",
drv_data->cur_chip->baud, drv_data->cur_chip->flag,
drv_data->cur_chip->ctl_reg);
dev_dbg(&drv_data->pdev->dev,
"the first transfer len is %d\n",
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment