I2C: S3C2410: Fixup error codes returned rom a transfer.

The driver should be returning -ENXIO for transfers that do not
pass the initial address byte stage.

Note, also small tidyups to the driver comments in the area.
Signed-off-by: Ben Dooks <ben-linux@fluff.org>

drivers/i2c/busses/i2c-s3c2410.c

@@ -290,12 +290,12 @@ static int i2s_s3c_irq_nextbyte(struct s3c24xx_i2c *i2c, unsigned long iicstat)
 		 * bus, or started a new i2c message
 		 */
 		
-		if (iicstat  & S3C2410_IICSTAT_LASTBIT &&
+		if (iicstat & S3C2410_IICSTAT_LASTBIT &&
 		    !(i2c->msg->flags & I2C_M_IGNORE_NAK)) {
 			/* ack was not received... */
 
 			dev_dbg(i2c->dev, "ack was not received\n");
-			s3c24xx_i2c_stop(i2c, -EREMOTEIO);
+			s3c24xx_i2c_stop(i2c, -ENXIO);
 			goto out_ack;
 		}
 
@@ -305,7 +305,7 @@ static int i2s_s3c_irq_nextbyte(struct s3c24xx_i2c *i2c, unsigned long iicstat)
 			i2c->state = STATE_WRITE;
 
 		/* terminate the transfer if there is nothing to do
-		 * (used by the i2c probe to find devices */
+		 * as this is used by the i2c probe to find devices. */
 
 		if (is_lastmsg(i2c) && i2c->msg->len == 0) {
 			s3c24xx_i2c_stop(i2c, 0);