ARM i.MX dma: Fix burstsize settings

dmaengine expects the maxburst parameter in words, not bytes.
The imxdma driver and its users do this wrong. Fix this.

As a side note the imx-pcm-dma-mx2 driver was 'fixed' to work
with imx-dma. This broke the driver with imx-sdma support which
correctly takes the maxburst parameter in words. This patch
puts the sdma based sound back to work.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

drivers/dma/imx-dma.c

@@ -135,7 +135,8 @@ static int imxdma_control(struct dma_chan *chan, enum dma_ctrl_cmd cmd,
 		if (ret)
 			return ret;
 
-		imx_dma_config_burstlen(imxdmac->imxdma_channel, imxdmac->watermark_level);
+		imx_dma_config_burstlen(imxdmac->imxdma_channel,
+				imxdmac->watermark_level * imxdmac->word_size);
 
 		return 0;
 	default:

drivers/mmc/host/mxcmmc.c

@@ -715,13 +715,13 @@ static void mxcmci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
 	int burstlen, ret;
 
 	/*
-	 * use burstlen of 64 in 4 bit mode (--> reg value  0)
-	 * use burstlen of 16 in 1 bit mode (--> reg value 16)
+	 * use burstlen of 64 (16 words) in 4 bit mode (--> reg value  0)
+	 * use burstlen of 16 (4 words) in 1 bit mode (--> reg value 16)
 	 */
 	if (ios->bus_width == MMC_BUS_WIDTH_4)
-		burstlen = 64;
-	else
 		burstlen = 16;
+	else
+		burstlen = 4;
 
 	if (mxcmci_use_dma(host) && burstlen != host->burstlen) {
 		host->burstlen = burstlen;

sound/soc/imx/imx-pcm-dma-mx2.c

@@ -110,12 +110,12 @@ static int imx_ssi_dma_alloc(struct snd_pcm_substream *substream,
 		slave_config.direction = DMA_TO_DEVICE;
 		slave_config.dst_addr = dma_params->dma_addr;
 		slave_config.dst_addr_width = buswidth;
-		slave_config.dst_maxburst = dma_params->burstsize * buswidth;
+		slave_config.dst_maxburst = dma_params->burstsize;
 	} else {
 		slave_config.direction = DMA_FROM_DEVICE;
 		slave_config.src_addr = dma_params->dma_addr;
 		slave_config.src_addr_width = buswidth;
-		slave_config.src_maxburst = dma_params->burstsize * buswidth;
+		slave_config.src_maxburst = dma_params->burstsize;
 	}
 
 	ret = dmaengine_slave_config(iprtd->dma_chan, &slave_config);