Commit 66c04e30 authored by Georgi Djakov's avatar Georgi Djakov Committed by Kumar Gala

ARM: dts: qcom: Add initial IFC6540 board device tree

Add basic support for the IFC6540 single-board computer boards, that are
based on the APQ8084 SoC. This patch adds the initial device tree and the
neccessary nodes required for enabling the serial port and eMMC.
Signed-off-by: default avatarGeorgi Djakov <gdjakov@mm-sol.com>
Signed-off-by: default avatarKumar Gala <galak@codeaurora.org>
parent 94ae991d
......@@ -341,6 +341,7 @@ dtb-$(CONFIG_ARCH_PRIMA2) += prima2-evb.dtb
dtb-$(CONFIG_ARCH_QCOM) += \
qcom-apq8064-ifc6410.dtb \
qcom-apq8074-dragonboard.dtb \
qcom-apq8084-ifc6540.dtb \
qcom-apq8084-mtp.dtb \
qcom-ipq8064-ap148.dtb \
qcom-msm8660-surf.dtb \
......
#include "qcom-apq8084.dtsi"
/ {
model = "Qualcomm APQ8084/IFC6540";
compatible = "qcom,apq8084-ifc6540", "qcom,apq8084";
soc {
serial@f995e000 {
status = "okay";
};
sdhci@f9824900 {
bus-width = <8>;
non-removable;
status = "okay";
};
sdhci@f98a4900 {
cd-gpios = <&tlmm 122 GPIO_ACTIVE_LOW>;
bus-width = <4>;
};
};
};
......@@ -3,6 +3,7 @@
#include "skeleton.dtsi"
#include <dt-bindings/clock/qcom,gcc-apq8084.h>
#include <dt-bindings/gpio/gpio.h>
/ {
model = "Qualcomm APQ 8084";
......@@ -193,5 +194,27 @@ serial@f995e000 {
clock-names = "core", "iface";
status = "disabled";
};
sdhci@f9824900 {
compatible = "qcom,sdhci-msm-v4";
reg = <0xf9824900 0x11c>, <0xf9824000 0x800>;
reg-names = "hc_mem", "core_mem";
interrupts = <0 123 0>, <0 138 0>;
interrupt-names = "hc_irq", "pwr_irq";
clocks = <&gcc GCC_SDCC1_APPS_CLK>, <&gcc GCC_SDCC1_AHB_CLK>;
clock-names = "core", "iface";
status = "disabled";
};
sdhci@f98a4900 {
compatible = "qcom,sdhci-msm-v4";
reg = <0xf98a4900 0x11c>, <0xf98a4000 0x800>;
reg-names = "hc_mem", "core_mem";
interrupts = <0 125 0>, <0 221 0>;
interrupt-names = "hc_irq", "pwr_irq";
clocks = <&gcc GCC_SDCC2_APPS_CLK>, <&gcc GCC_SDCC2_AHB_CLK>;
clock-names = "core", "iface";
status = "disabled";
};
};
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment