dmaengine: st_fdma: Add STMicroelectronics FDMA engine driver support

This patch adds support for the Flexible Direct Memory Access (FDMA) core
driver. The FDMA is a slim core CPU with a dedicated firmware.
It is a general purpose DMA controller capable of supporting 16
independent DMA channels. Data moves maybe from memory to memory
or between memory and paced latency critical real time targets and it
is found on al STi based chipsets.
Signed-off-by: Ludovic Barre <ludovic.barre@st.com>
Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>

drivers/dma/Kconfig

@@ -435,6 +435,19 @@ config STE_DMA40
 	help
 	  Support for ST-Ericsson DMA40 controller
 
+config ST_FDMA
+	tristate "ST FDMA dmaengine support"
+	depends on ARCH_STI
+	select ST_SLIM_REMOTEPROC
+	select DMA_ENGINE
+	select DMA_VIRTUAL_CHANNELS
+	help
+	  Enable support for ST FDMA controller.
+	  It supports 16 independent DMA channels, accepts up to 32 DMA requests
+
+	  Say Y here if you have such a chipset.
+	  If unsure, say N.
+
 config STM32_DMA
 	bool "STMicroelectronics STM32 DMA support"
 	depends on ARCH_STM32 || COMPILE_TEST

drivers/dma/Makefile

@@ -67,6 +67,7 @@ obj-$(CONFIG_TI_DMA_CROSSBAR) += ti-dma-crossbar.o
 obj-$(CONFIG_TI_EDMA) += edma.o
 obj-$(CONFIG_XGENE_DMA) += xgene-dma.o
 obj-$(CONFIG_ZX_DMA) += zx296702_dma.o
+obj-$(CONFIG_ST_FDMA) += st_fdma.o
 
 obj-y += qcom/
 obj-y += xilinx/