Commit 6c482fd1 authored by Nicolas Ferre's avatar Nicolas Ferre

ARM: dts: at91: sama5d2 xplained: add phy address and IRQ for macb0

After 57a38eff (net: phy: micrel: disable broadcast for KSZ8081/KSZ8091)
the macb0 interface has difficulties to come back from power saving mode if
address not explicitly set up.
As the micrel phy on the board is actually configured to show up at address 1
we use this explicitly.
Adding the phy node and its real address fixes the issue.

The phy IRQ and associated pinmux node is also added.
Signed-off-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: default avatarAlexandre Belloni <alexandre.belloni@free-electrons.com>
Cc: stable@vger.kernel.org # 4.4+ // manual merge needed
parent 1a469ae2
...@@ -114,9 +114,15 @@ m25p80@0 { ...@@ -114,9 +114,15 @@ m25p80@0 {
macb0: ethernet@f8008000 { macb0: ethernet@f8008000 {
pinctrl-names = "default"; pinctrl-names = "default";
pinctrl-0 = <&pinctrl_macb0_default>; pinctrl-0 = <&pinctrl_macb0_default &pinctrl_macb0_phy_irq>;
phy-mode = "rmii"; phy-mode = "rmii";
status = "okay"; status = "okay";
ethernet-phy@1 {
reg = <0x1>;
interrupt-parent = <&pioA>;
interrupts = <73 IRQ_TYPE_LEVEL_LOW>;
};
}; };
pdmic@f8018000 { pdmic@f8018000 {
...@@ -300,6 +306,10 @@ pinctrl_macb0_default: macb0_default { ...@@ -300,6 +306,10 @@ pinctrl_macb0_default: macb0_default {
bias-disable; bias-disable;
}; };
pinctrl_macb0_phy_irq: macb0_phy_irq {
pinmux = <PIN_PC9__GPIO>;
};
pinctrl_pdmic_default: pdmic_default { pinctrl_pdmic_default: pdmic_default {
pinmux = <PIN_PB26__PDMIC_DAT>, pinmux = <PIN_PB26__PDMIC_DAT>,
<PIN_PB27__PDMIC_CLK>; <PIN_PB27__PDMIC_CLK>;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment