spi: spi-fsl-dspi: use XSPI mode instead of DMA for DPAA2 SoCs

The arch/arm64/boot/dts/freescale/fsl-ls208xa.dtsi device tree lacks DMA
channels for DSPI, so naturally, the driver fails to probe:

[ 2.945302] fsl-dspi 2100000.spi: rx dma channel not available
[ 2.951134] fsl-dspi 2100000.spi: can't get dma channels

In retrospect, this should have been obvious, because LS2080A, LS2085A
LS2088A and LX2160A don't appear to have an eDMA module at all. Looking
again at their datasheets, the CTARE register (which is specific to XSPI
functionality) seems to be documented, so switch them to XSPI mode
instead.

Fixes: 0feaf8f5 ("spi: spi-fsl-dspi: Convert the instantiations that support it to DMA")
Reported-by: Qiang Zhao <qiang.zhao@nxp.com>
Tested-by: Qiang Zhao <qiang.zhao@nxp.com>
Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Link: https://lore.kernel.org/r/20200910121532.1138596-1-olteanv@gmail.comSigned-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-fsl-dspi.c

@@ -171,17 +171,17 @@ static const struct fsl_dspi_devtype_data devtype_data[] = {
 		.fifo_size		= 16,
 	},
 	[LS2080A] = {
-		.trans_mode		= DSPI_DMA_MODE,
+		.trans_mode		= DSPI_XSPI_MODE,
 		.max_clock_factor	= 8,
 		.fifo_size		= 4,
 	},
 	[LS2085A] = {
-		.trans_mode		= DSPI_DMA_MODE,
+		.trans_mode		= DSPI_XSPI_MODE,
 		.max_clock_factor	= 8,
 		.fifo_size		= 4,
 	},
 	[LX2160A] = {
-		.trans_mode		= DSPI_DMA_MODE,
+		.trans_mode		= DSPI_XSPI_MODE,
 		.max_clock_factor	= 8,
 		.fifo_size		= 4,
 	},